Porous SnO2Films Fabricated Using an Anodizing Process
نویسندگان
چکیده
منابع مشابه
Pore Formation Process of Porous Ti3SiC2 Fabricated by Reactive Sintering
Porous Ti3SiC2 was fabricated with high purity, 99.4 vol %, through reactive sintering of titanium hydride (TiH2), silicon (Si) and graphite (C) elemental powders. The reaction procedures and the pore structure evolution during the sintering process were systematically studied by X-ray diffraction (XRD) and scanning electron microscope (SEM). Our results show that the formation of Ti3SiC2 from ...
متن کاملNano-porous anodic aluminium oxide membranes with 6–19 nm pore diameters formed by a low-potential anodizing process
Self-organized nano-porous anodic aluminium oxide (AAO) membranes with small pore diameters were obtained by applying a low anodizing potential in sulfuric acid solutions. The pore diameters of the as-prepared AAO membranes were in the range of about 6–19 nm and the interpore distances were about 20–58 nm. Low potentials (6–18 V) were applied in anodizing processes to make such small pores. A l...
متن کاملUltra-High Density Single Nanometer-Scale Anodic Alumina Nanofibers Fabricated by Pyrophosphoric Acid Anodizing
Anodic oxide fabricated by anodizing has been widely used for nanostructural engineering, but the nanomorphology is limited to only two oxides: anodic barrier and porous oxides. Therefore, the discovery of an additional anodic oxide with a unique nanofeature would expand the applicability of anodizing. Here we demonstrate the fabrication of a third-generation anodic oxide, specifically, anodic ...
متن کاملThe Comparison of Possibilities at Using of Different Electrolytes in the Process of Anodizing Aluminum
M. Gombar, J. Kmec, Faculty of Management, University of Presov, Presov; M. Badida, L. Sobotova, Faculty of Mechanical Engineering, Technical University of Kosice, Košice, Slovakia The contribution researches and solves the suitability of utilize of electrolyte, consisting of the oxalic acid, boric acid, sodium chloride and aluminium cations in the process of anodizing aluminium in operating co...
متن کاملAn Acetone Microsensor with a Ring Oscillator Circuit Fabricated Using the Commercial 0.18 μm CMOS Process
This study investigates the fabrication and characterization of an acetone microsensor with a ring oscillator circuit using the commercial 0.18 μm complementary metal oxide semiconductor (CMOS) process. The acetone microsensor contains a sensitive material, interdigitated electrodes and a polysilicon heater. The sensitive material is α-Fe2O3 synthesized by the hydrothermal method. The sensor re...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Korean Journal of Materials Research
سال: 2006
ISSN: 1225-0562
DOI: 10.3740/mrsk.2006.16.8.503