Pore Formation in Micro-grained WC-Ni Alloy.
نویسندگان
چکیده
منابع مشابه
Coarse-grained simulation studies of peptide-induced pore formation.
We investigate the interactions between lipid bilayers and amphiphilic peptides using a solvent-free coarse-grained simulation technique. In our model, each lipid is represented by one hydrophilic and three hydrophobic beads. The amphiphilic peptide is modeled as a hydrophobic-hydrophilic cylinder with hydrophilic caps. We find that with increasing peptide-lipid attraction the preferred state o...
متن کاملUltrafine-Grained Structure of Fe-Ni-C Austenitic Alloy Formed by Phase Hardening
The X-ray and magnetometry methods were used to study α-γ transformation mechanisms on heating quenched Fe-22.7 wt.% Ni-0.58 wt.% С alloy. Variation of heating rate within 0.03-80 K/min allowed one to switch from diffusive to non-diffusive mechanism of the α-γ transformation. Heating up primary austenitic single crystal specimen at a rate of less than 1.0-0.5 K/min has led to formation of aggre...
متن کاملNanostructurization of Fe-Ni Alloy
Data about an effect of cyclic γ-α-γ martensitic transformations on the structure state of reverted austenite Fe-31.7 wt.% Ni-0.06 wt.% C alloy are presented. The effect of multiple direct γ-α and reverse α-γ martensitic transformations on fragmentation of austenitic grains has been investigated by electron microscopy and X-ray diffraction methods. An ultrafine structure has been formed by nano...
متن کاملEffect of WC Concentration on Abrasive Wear Properties of the Thermally Sprayed WC -Ni Coatings
In this work the effects of WC concentration on abrasive wear behavior by thermally sprayed WC coating was evaluated using three body abrasive wear tester. A different combination of WC and NI coatings were deposited on steel substrates by flame spraying using powder with different WC concentrations (0 %, 12.5 %, 25 %, and 50 %). Flame torch was used for heating and coating of process. Microstr...
متن کاملDynamic Micro-strain Analysis of Ultrafine-grained Aluminum Magnesium alloy using Digital Image Correlation
Tensile tests were performed in situ on an ultrafine-grained (UFG) Al-Mg alloy using a micro-tensile module in a scanning electron microscope (SEM). The micro-strain evolution was tracked and measured using digital image correlation (DIC). A fine random speckle pattern was required to achieve high resolution and accuracy of strain measurement using DIC. To produce the speckle pattern, a pattern...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1995
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.42.1341