Pool Boiling on a Platinum Wire at Subatmospheric Pressures

Secondary pool boiling effects

Highly subcooled pool boiling heat transfer at various gravity levels

A microscale heater array 2:7 mm 2:7 mm in size along with a video camera was used to provide subcooled pool boiling heat transfer measurements at gravity levels ranging from 1.8g to 10 g. The fluid was FC-72 at 1 atm and subcooled by nominally 36 C for all cases. A Terrier–Orion sounding rocket and the KC-135 aircraft were used to provide the microgravity and low-g environments, respectively. ...

Transient pool boiling in microgravityt

Transient nucleate pool boiling experiments using R113 are conducted for short times in microgravity and in earth gravity with different heater surface orientations and subcoolings. The heating surface is a transparent gold film sputtered on a quartz substrate, which simultaneously provides surface temperature measurements and permits viewing of the boiling process from beneath. For the microgr...

Pool Boiling Heat Transfer in Water/Amines Solutions

In this investigation, nucleate boiling heat transfer coefficients were experimentally measured during pool boiling of mixtures, consisting of water/monoethanolamine and water/diethanolamine on a horizontal heating rod, under atmospheric pressure. The experiment was carried out below 205 kW.m-2 heat flux, over a wide range of concentrations. These experiments include, measurement of pool boilin...

Effect of open microchannel geometry on pool boiling enhancement

Pool boiling enhancement through surface modification has garnered the attention of many researchers for extending the limits of heat flux dissipation. Simulated copper chips were used in a pool boiling setup with water boiling at atmospheric pressure. Heat transfer performance of different microchanneled surfaces was compared to that of a plain surface. The results of the study showed that the...