Polypropylene-Based Porous Membranes: Influence of Polymer Composition, Extrusion Draw Ratio and Uniaxial Strain
نویسندگان
چکیده
منابع مشابه
Numerical Computation of Extrusion and Draw-extrusion Cable-coating Flows with Polymer Melts
This paper is concerned with the numerical solution of polymer melt flows of both extrudate-swell and tube-tooling die-extrusion coatings, using a hybrid finite element/finite volume discretisation fe/fv. Extrudate-swell presents a single dynamic freesurface, whilst the complex polymer melt coating flow exhibit two separate free-surface draw-down sections to model, an inner and outer conduit su...
متن کاملEffects of Fumed Silica and Draw Ratio on Nanocomposite Polypropylene Fibers
Hydrophylic fumed silica AR974 was tested as a potential nanofiller for the production of composite isotactic polypropylene filaments/fibers (containing 0.25–2 vol % of nanoparticles) via melt compounding and subsequent hot drawing. The objectives of this study were as follows: (i) to investigate the effects of the composition and the processing conditions on the microstructure and the thermal ...
متن کاملExtrusion of Linear Polypropylene–Clay Nanocomposite Foams
This work presents new results on using organoclay with an appropriate polymeric compatibilizer as rheology-modifying additives for extrusion foaming of a linear polypropylene (PP), which by itself does not display strain hardening in extensional flow of the melt. The uniaxial melt-extensional viscosity behavior of several nanocomposites prepared with varying ratio of bound maleic anhydride to ...
متن کاملMetamaterial Behavior of Polymer Nanocomposites Based on Polypropylene/Multi-Walled Carbon Nanotubes Fabricated by Means of Ultrasound-Assisted Extrusion
Metamaterial behavior of polymer nanocomposites (NCs) based on isotactic polypropylene (iPP) and multi-walled carbon nanotubes (MWCNTs) was investigated based on the observation of a negative dielectric constant (ε'). It is demonstrated that as the dielectric constant switches from negative to positive, the plasma frequency (ωp) depends strongly on the ultrasound-assisted fabrication method, as...
متن کاملUltrasound-Assist Extrusion Methods for the Fabrication of Polymer Nanocomposites Based on Polypropylene/Multi-Wall Carbon Nanotubes
Isotactic polypropylenes (iPP) with different melt flow indexes (MFI) were used to fabricate nanocomposites (NCs) with 10 wt % loadings of multi-wall carbon nanotubes (MWCNTs) using ultrasound-assisted extrusion methods to determine their effect on the morphology, melt flow, and electrical properties of the NCs. Three different types of iPPs were used with MFIs of 2.5, 34 and 1200 g/10 min. Fou...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymers
سال: 2017
ISSN: 2073-4360
DOI: 10.3390/polym10010033