Polyimide Asymmetric Membrane vs. Dense Film for Purification of MTBE Oxygenate by Pervaporation
نویسندگان
چکیده
منابع مشابه
Analysis of Mtbe as an Oxygenate Additive to Gasoline
One of the major drawbacks of IC engines is low efficiency and pollution resulting from incomplete combustion. In order to improve the emission properties and performance an oxygenated additive MTBE (Methyl tertiary butyl ether), is blended with gasoline. A four cylinder, 1817 cc engine was used for analysing both emission and performance characteristics. Tests were carried out with 100% pure g...
متن کاملPervaporation: Membrane Separations
G-100 is used for higher molecular mass proteins. The solutions of proteins are prepared in guanidine hydrochloride (10 mg mL ), and cytochromec (10 mg mL ) is used as an internal standard. Descending chromatography is carried out at room temperature under an inclination angle of 253 to the horizontal. After 3 h of development the quotient Rs protein/Rs cytochrome c is calculated for each prote...
متن کاملstudy of cohesive devices in the textbook of english for the students of apsychology by rastegarpour
this study investigates the cohesive devices used in the textbook of english for the students of psychology. the research questions and hypotheses in the present study are based on what frequency and distribution of grammatical and lexical cohesive devices are. then, to answer the questions all grammatical and lexical cohesive devices in reading comprehension passages from 6 units of 21units th...
EFFECT OF OPERATING CONDITIONS ON THE DEHYDRATION OF TOLUENE BY PERVAPORATION USING A POLYVINYL ALCOHOL MEMBRANE
The effects of operating parameters such as feed temperature and permeate-side pressure on the performance of a commercial PVA membrane in the dehydration of toluene by a pervaporation (PV) membrane system is studied in the present work. The results obtained indicate that increasing temperature in the range of 40 to 70 °C and reducing permeate pressure in the range of 1 to 10 mmHg increase memb...
متن کاملSurface Plasma Treatment of Polyimide Film for Cu Metallization
Surface modification of polyimide films by oxygen/argon atmospheric pressure plasma (APP) was studied for copper metallization under several conditions, including plasma treatment time, gas ratio, and power of radio frequency (RF; 13.56MHz) plasma. The effects of APP treatments on the surface properties of polyimide (PI) films were investigated in terms of Fourier-transform infrared (FT-IR) spe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Symmetry
سال: 2020
ISSN: 2073-8994
DOI: 10.3390/sym12030436