Polyaniline(PANI) coated Zn2SnO4 cube as anode materials for lithium batteries
نویسندگان
چکیده
منابع مشابه
Porous Si anode materials for lithium rechargeable batteries
Si anode materials for lithium rechargeable batteries have received much attention due to their high capacity. The Si itself can alloy with lithium up to Li4.4Si, corresponding to 4212 mAh/ g (4.4Li + Si 4 Li4.4Si). However, the large volume expansion of over 300% due to the formation of various LixSiy phases generates enormous mechanical stress within the ionic character material, which become...
متن کاملInitial Discharge Capacity of Manganese Cobaltite as Anode Material for Lithium Ion Batteries
Nanostructured manganese cobalt oxide spinel (MnCo2O4) are prepared by co-precipitation method and calcined at 650 and 750°C. Morphological studies show that by increasing the calcination temperature from 650 to 750°C, morphology of the particles changes from quasi-plate to polyhedral. The MnCo2O4 calcined at 650°C could deliver an initial discharge capacity of 1438 mAh g-1 under current densit...
متن کاملCarbon-coated mesoporous SnO2 nanospheres as anode material for lithium ion batteries
In this paper mesoporous SnO2 nanospheres with an average diameter of about 83 nm, composed of many tiny primary particles ( 10 nm) and holes, are synthesized on a large scale by a simple hydrothermal route. The as-prepared mesoporous SnO2 nanospheres were uniformly coated with carbon by a further hydrothermal treatment in glucose aqueous solution. As anode materials for lithium-ion batteries, ...
متن کاملSingle-walled carbon nanohorns coated with Fe2O3 as a superior anode material for lithium ion batteries.
A novel composite of Fe(2)O(3) and single-walled carbon nanohorns (SWCNHs) was firstly developed via a simple hydrothermal method. As an anode material for lithium ion batteries, a Fe(2)O(3)/SWCNHs composite shows excellent rate performance and cycle stability, even at a high current density of 1000 mA g(-1).
متن کاملElectrochemical Evaluation of PbO Nanoparticles as Anode for Lithium Ion Batteries (Technical Note)
PbO nanoparticles were synthesized using hydrothermal process. Scanning electron microscopy (SEM) was used in order to investigate of PbO powders. X-ray diffraction (XRD) pattern confirmed β-PbO formation during this process. The crystallite size of the powders was calculated using Scherrer formula about 74.6 nm. Electrochemical evaluation of the PbO nanoparticles as anode for Li-ion batteries ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymer Testing
سال: 2013
ISSN: 0142-9418
DOI: 10.1016/j.polymertesting.2013.10.012