Polarizing beam splitter for dipolar molecules
نویسندگان
چکیده
منابع مشابه
Four-port integrated polarizing beam splitter.
In this Letter, we report on the first integrated four-port polarizing beam splitter. The device operates on the principle of mode evolution and was implemented in a silicon-on-insulator silicon photonics platform and fabricated on a 300 mm CMOS line using 193 nm optical immersion lithography. The adiabatic transition forming of the structure enabled over a 150 nm bandwidth from λ~1350 to λ~150...
متن کاملParallel-slab polarizing beam splitter and photopolarimeter.
A dielectric-slab polarizing beam splitter (PBS) is described that generates two parallel beams of orthogonal p and s linear polarizations in reflection and functions as a diattenuator in transmission. The plane-parallel slab, which is set at Brewster's angle, is uncoated on one side and has an s-polarization antireflection coating (s-ARC) on the other side. Analytical results are presented for...
متن کاملPolarizing beam-splitter based on defective photonic crystals
The performance of a polarizing beam splitter based on the one-dimensional photonic crystals (1D-PCs), is theoretically investigated. The polarizing beam splitter consists of a symmetric stack of the low-index quarter-wave plates and the high-index half-wave plates with a central defect layer of air. The linear transmission properties of the polarizing beam splitter are numerically simulat...
متن کاملStudy of the injection molding of a polarizing beam splitter.
We describe the replication of a relief grating that behaves like a polarizing beam splitter by injection molding. Measurements of the grating master, nickel shim, and replica, performed by atomic force microscopy, allow establishing a limit for the injection molding technique (currently used in CD fabrication) to aspect ratios of approximately 0.15. Although this limit strongly reduces the dif...
متن کامل3D-Printed Beam Splitter for Polar Neutral Molecules
We describe a macroscopic beam splitter for polar neutral molecules. A complex electrode structure is required for the beam splitter which would be very difficult to produce with traditional manufacturing methods. Instead, we make use of a nascent manufacturing technique: 3D printing of a plastic piece, followed by electroplating. This fabrication method opens a plethora of avenues for research...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Physical Review A
سال: 2005
ISSN: 1050-2947,1094-1622
DOI: 10.1103/physreva.71.051601