PLC-controlled stepper motor drive for NC positioning system
نویسندگان
چکیده
منابع مشابه
New Positioning Control of Stepper Motor using BP Neural Networks
This paper presents a new approach based on the use of a knowledge base, in order to improve the angular resolution of the permanent magnet (PM) stepper actuator. The use of this technique is justified by the limits of the conventional technique when the static torque characteristic is high nonlinear. The conventional open loop microstepping technique which realised by a Pulse Width Modulation ...
متن کاملA Digitally Controlled Drive System for Travelling-wave Ultrasonic Motor
A digitally controlled drive system was implemented in this study to control the speed and direction of a travelling-wave ultrasonic motor. The drive system, based on a 2-phase voltage-fed high-frequency serial-resonant inverter, uses the mechanical resonant frequency of an ultrasonic motor. A TMS320F243 digital signal processor was used to control an ultrasonic motor drive system. The speed co...
متن کاملFrequency Controlled Ac Motor Drive
1.0 Features of Standard AC Motors The squirrel cage induction motor is the electrical motor motor type most widely used in industry. This leading position results mainly from certain excellent features of the squirrel cage motor such as: • Uncomplicated, rugged construction. For the user this means low initial cost and high reliability. • Good efficiency coupled with low maintenance costs resu...
متن کاملStepper Motor Actuated Microvalve
We present the design, fabrication and characterization of a novel microvalve realized by combining micro and fine machining techniques. The design is for high flow rates at high pressure difference between inlet and outlet, burst pressure of up to 15 bars, there is no power consumption required for the valve to maintain its position during operation in any intermediate state and the process ga...
متن کاملSimulating the Arm Movements of a Stepper Motor Controlled Pick- and-Place Robot Using the Stepper Motor Model
This paper describes the simulation of arm movements of a stepper motor controlled pickand-place robot using the mathematical model of a stepper motor. The model includes: a) a model of the stepper model driver board, b) a model of the hybrid stepper motor and load combination, and c) the interconnection of the two models which is used to simulate the motions of the base, shoulder, elbow, and w...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Engineering & Technology
سال: 2014
ISSN: 2227-524X
DOI: 10.14419/ijet.v3i3.2796