Plate with holes as shear connector in cold formed steel composite beams
نویسندگان
چکیده
منابع مشابه
Comparison of plasticity and stiffness of steel shear walls with composite steel plate shear wall
The steel shear wall and composite steel plate shear wall is introduced in recent three decade and is considered and is spread rapidly. Composite steel plate shear wall which is made of a layer of thin steel sheet with coating of reinforced concrete in one or both sides of steel palate is considered a third generation of resistance shear walls against lateral loads that in addition to increasin...
متن کاملSeismic Behavior of Intermediate Beams in Steel Plate Shear Walls
This paper presents some preliminary results of an ongoing research whose objective is to investigate the seismic behavior of intermediate beams (i.e., the beams other than those at the roof and foundation levels) in multi-story steel plate shear walls (SPSWs). Of primary interest is the determination of the strength level needed to avoid the formation of in-span plastic hinges, a relevant prac...
متن کاملLocal Buckling Tests on Cold-Formed Steel Beams
C and Z sections are two of the most common cold-formed steel shapes in use today. Accurate prediction of the bending performance of these sections is important for reliable and efficient cold-formed steel structures. Recent analytical work has highlighted discontinuities and inconsistencies in the American Iron and Steel Institute ~AISI! and Canadian Standards Association ~S136! design provisi...
متن کاملDistortional Buckling Tests on Cold-Formed Steel Beams
Failure in cold-formed steel beams is generally initiated by one of three instabilities: local, distortional, or lateral-torsional buckling. For cold-formed steel joists, purlins, or girts, when the compression flange is not restrained by attachment to sheathing or paneling, distortional buckling may be the predominant failure mode. Experimental results on cold-formed steel beams with unrestrai...
متن کاملExperimental Investigation on Cold-formed Steel Wall Plate System
A series of tests on cold-formed steel (CFS) wall plate system subjected to uplift force at the mid span of the wall plate is presented. The aim of the study was to study the behaviour and identify the modes of failure of CFS wall plate system. Two parameters were considered in these studies: 1) different dimension of U-bracket at the supports and 2) different sizes of lipped Cchannel. The lipp...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Revista IBRACON de Estruturas e Materiais
سال: 2019
ISSN: 1983-4195
DOI: 10.1590/s1983-41952019000300005