PLASTIC DEFORMATION ANALYSIS OF COARSE GRANULAR MATERIAL UNDER CYCLIC MOVING WHEEL LOADS BY CUMULATIVE DAMAGE MODEL
نویسندگان
چکیده
منابع مشابه
Analysis of a Beam under Moving Loads
Abstract: It is assumed that a beam made of material has a physical nonlinear behavior. This beam is analyzed under the moving concentrated and distributed continuous loads. The vibration equations of motion are derived from the Hamilton's Principle and Euler–Lagrange Equation. In this study, the amplitude of vibration, circular frequency, bending moment, stress and deflection of the beam has b...
متن کاملNumerical Analysis of Severe Plastic Deformation by High Pressure Torsion
High-pressure torsion (HPT) is a metal processing method in which the sample is subjected to a very high plastic shear deformation. This process can produce exceptional levels of grain refinement, and provides a corresponding improvement in mechanical properties. To investigate the stress and strain distribution due to HPT process finite element simulation were conducted to investigate effectiv...
متن کاملDamage Detection of Bridge Beam Structures under Moving Loads
System identification technique is used widely in the damage assessment of engineering structures. It is regarded as the key part of a structural health monitoring system, which identifies the physical parameters from the raw measurement data. The changes in the identified parameters will be used to assess the damage of the structure. Most system identification methods need the input loading an...
متن کاملCompaction of a granular material under cyclic shear
In this paper we present experimental results concerning the compaction of a granular assembly of spheres under periodic shear deformation. The dynamic of the system is slow and continuous when the amplitude of the shear is constant, but exhibits rapid evolution of the volume fraction when a sudden change in shear amplitude is imposed. This rapid response is shown to be to be uncorrelated with ...
متن کاملShear Deformation in Granular Material
An investigation into the properties of granular materials is undertaken via numerical simulation. These simulations highlight that frictional contact, a defining characteristic of dry granular materials, and interfacial debonding, an expected deformation mode in plastic bonded explosives, must be properly modeled. Frictional contact and debonding algorithms have been implemented into FLIP, a p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JOURNAL OF PAVEMENT ENGINEERING, JSCE
سال: 2007
ISSN: 1884-8176
DOI: 10.2208/journalpe.12.47