Plasma Process Modeling for Integrated Circuits Manufacturing
نویسندگان
چکیده
منابع مشابه
Modeling the Random Component of Manufacturing Yield of Integrated Circuits
A model is created for the number of integrated circuits that are good from each wafer on which they are fabricated. The goal is to separate the random or common cause loss from the systematic or special loss. The random loss from this type of process is modeled so that false alarms indicating systematic loss are less likely to occur and so that the structure of the systematic loss can be deter...
متن کاملMetrology Requirements for Manufacturing 3d Integrated Circuits
Three-dimensional integrated circuits (3D ICs) introduce wafer bonding and Through Silicon Vias (TSVs) as new modules, thus extending manufacturing requirements beyond CMOS. A 3D IC with a photosensor is taken as an example to further analyze the resulting new metrology requirements for mass production. For the wafer bond module, data on defects before and after bonding, bond interface adhesion...
متن کاملManufacturing Process Modeling and Simulation
This paper presents a methodology to be employed in the whole process design phase including first and second processing. This methodology consists of a set of steps which are characterised by an independent model. This paper’s objective is to analyse the coherence between the different models and the coherence between the model and the objectives of each step. The final stage is to develop the...
متن کاملA MEMS Capacitive Microphone Modelling for Integrated Circuits
In this paper, a model for MEMS capacitive microphone is presented for integrated circuits. The microphone has a diaphragm thickness of 1 μm, 0.5 × 0.5 mm2 dimension, and an air gap of 1.0 μm. Using the analytical and simulation results, the important features of MEMS capacitive microphone such as pull-in voltage and sensitivity are obtained 3.8v and 6.916 mV/Pa, respectively while there is no...
متن کاملAn Integrated Software System for Process Planning for Layered Manufacturing
An integrated process planning system for layered manufacturing (LM) reduces the time between design and part fabrication and improves the quality of the final part. Process planning for most LM processes includes part orientation, support structure generation, slicing, and path planning. In this paper we describe an integrated process planning system we are developing. Our software accommodate...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: VLSI Design
سال: 1998
ISSN: 1065-514X,1563-5171
DOI: 10.1155/1998/27636