Plane Strain Test for Metal Sheet Characterization
نویسندگان
چکیده
منابع مشابه
Bending-Unbending Analysis of Anisotropic Sheet under Plane Strain Condition
The mechanical behavior of cold rolled sheets is significantly related to residual stresses that arise from bending and unbending processes. Measurement of residual stresses is mostly limited to surface measurement techniques. Experimental determination of stress variation through thickness is difficult and time-consuming. This paper presents a closed form solution for residual stresses, in whi...
متن کاملBending-Unbending Analysis of Anisotropic Sheet under Plane Strain Condition
The mechanical behavior of cold rolled sheets is significantly related to residual stresses that arise from bending and unbending processes. Measurement of residual stresses is mostly limited to surface measurement techniques. Experimental determination of stress variation through thickness is difficult and time-consuming. This paper presents a closed form solution for residual stresses, in whi...
متن کاملPlane-strain bulge test for thin films
The plane-strain bulge test is a powerful new technique for measuring the mechanical properties of thin films. In this technique, the stress–strain curve of a thin film is determined from the pressure-deflection behavior of a long rectangular membrane made of the film of interest. For a thin membrane in a state of plane strain, film stress and stain are distributed uniformly across the membrane...
متن کاملThrough-Thickness Stresses in Automotive Sheet Metal after Plane Strain Channel Draw
Abstract. A series of samples from four automotive materials AKDQ, HSLA50, DP600, and AA6022-T43 were deformed in a channel draw processes with different levels of draw bead penetration. As a result, varying magnitudes of deformations in plane strain mode and residual stresses were obtained. Through-thickness stress profiles were obtained non-destructively using a novel, high resolution X-ray d...
متن کاملLiquid Metal Strain Gage to Test Cervical Facet Capsule Strain
A broad range of investigations has been carried out to suggest that the facet joint capsule is a source of neck pain and the pain may arise from large strain in the cervical facet capsule that will cause pain receptors to fire. So far, no direct methods to in vivo test the cervical facet capsule strain during rearend crashes have been known. To solve this methodology problem, a special liquid ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Key Engineering Materials
سال: 2007
ISSN: 1662-9795
DOI: 10.4028/www.scientific.net/kem.344.135