Physical Properties Improvement of High Aspect Ratio Plastic-Molding Parts
نویسندگان
چکیده
منابع مشابه
Study of Aspect Ratio Effect on Mechanical Properties Polymer/NanoComposite
Carbon nanotubes (CNTs) demonstrate unusually high stiffness, strength and resilience, and are therefore an ideal reinforcing material for nanocomposites. However, much work has to be done before the potentials of CNT-based composites can be fully realized. Evaluating the effective material properties of such nanoscale materials is a very difficult tasks. Simulations using molecular dynamics ...
متن کاملdetermination of some physical and mechanical properties red bean
چکیده: در این تحقیق، برخی خواص فیزیکی و مکانیکی لوبیا قرمز به-صورت تابعی از محتوی رطوبت بررسی شد. نتایج نشان داد که رطوبت بر خواص فیزیکی لوبیا قرمز شامل طول، عرض، ضخامت، قطر متوسط هندسی، قطر متوسط حسابی، سطح تصویر شده، حجم، چگالی توده، تخلخل، وزن هزار دانه و زاویه ی استقرار استاتیکی در سطح احتمال 1 درصد اثر معنی داری دارد. به طوری که با افزایش رطوبت از 54/7 به 12 درصد بر پایه خشک طول، عرض، ضخام...
15 صفحه اولShrink film patterning by craft cutter: complete plastic chips with high resolution/high-aspect ratio channel.
This paper presents a rapid, ultra-low-cost approach to fabricate microfluidic devices using a polyolefin shrink film and a digital craft cutter. The shrinking process (with a 95% reduction in area) results in relatively uniform and consistent microfluidic channels with smooth surfaces, vertical sidewalls, and high aspect ratio channels with lateral resolutions well beyond the tool used to cut ...
متن کاملHigh-resolution, high-aspect ratio conductive wires embedded in plastic substrates.
A novel method is presented to fabricate high-resolution, high-aspect ratio metal wires embedded in a plastic substrate for flexible electronics applications. In a sequential process, high-resolution channels connected to low-resolution reservoirs are first created in a thermosetting polymer by imprint lithography. A reactive Ag ink is then inkjet-printed into the reservoirs and wicked into the...
متن کاملDynamic of Taking out Molding Parts at Injection Molding
E. Ragan, J. Dobránsky, P. Baron, M. Kočiško, J. Svetlík, Technical University in Košice, Slovakia Most plastic parts used in automobile production are manufactured by injection molding. Their quality depends also on taking out molding and on the manipulators for it. Task of this contribution is to theoretically describe a transport of molding at taking out after injection molding in relation o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 2014
ISSN: 0514-5163,1880-7488
DOI: 10.2472/jsms.63.757