Photosensitive protein patterning with electrophoretic deposition
نویسندگان
چکیده
منابع مشابه
Electrophoretic Deposition of Hydroxyapatite
The purpose of this study was to investigate the deposition of the hydroxyapatite (HA) coating via the electrophoresis procedure. The HA deposition was performed in an ethanol, methanol, acetone and isopropanol suspension. Methanol was found to be the best deposition media. Among the different environmental conditions, including the encapsulation of the samples under two vacuum types of pr...
متن کاملelectrophoretic deposition of hydroxyapatite
the purpose of this study was to investigate the deposition of the hydroxyapatite (ha) coating via the electrophoresis procedure. the ha deposition was performed in an ethanol, methanol, acetone and isopropanol suspension. methanol was found to be the best deposition media. among the different environmental conditions, including the encapsulation of the samples under two vacuum types of pressur...
متن کاملElectrophoretic Deposition of Gallium with High Deposition Rate
In this work, electrophoretic deposition (EPD) is reported to form gallium thin film with high deposition rate and low cost while avoiding the highly toxic chemicals typically used in electroplating. A maximum deposition rate of ~0.6 μm/min, almost one order of magnitude higher than the typical value reported for electroplating, is obtained when employing a set of proper deposition parameters. ...
متن کاملElectrophoretic deposition of biomaterials.
Electrophoretic deposition (EPD) is attracting increasing attention as an effective technique for the processing of biomaterials, specifically bioactive coatings and biomedical nanostructures. The well-known advantages of EPD for the production of a wide range of microstructures and nanostructures as well as unique and complex material combinations are being exploited, starting from well-disper...
متن کاملElectrophoretic Deposition: Fundamentals and Applications
This article presents a study on the growth process for the template-based growth of TiO2 nanorods by sol electrophoretic deposition, through both experiment and simulation. Uniformly sized nanorods of approximately 45–200 nm in diameter and 10–60 μm in length can be grown over large areas with near unidirectional alignment. The nanorods have the desired stoichiometric chemical composition and ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEICE Electronics Express
سال: 2010
ISSN: 1349-2543
DOI: 10.1587/elex.7.779