Photodiode Camera Measurement of Surface Strains on Tendons during Multiple Cyclic Tests

نویسندگان
چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

the washback effect of discretepoint vs. integrative tests on the retention of content in knowledge tests

در این پایان نامه تاثیر دو نوع تست جزیی نگر و کلی نگر بر به یادسپاری محتوا ارزیابی شده که نتایج نشان دهندهکارایی تستهای کلی نگر بیشتر از سایر آزمونها است

15 صفحه اول

the effect of e-64 on the developmental competence of sheep cocs during in vitro maturation

in the present study, the effect of e-64 at different concentrations (0.5, 1, 5 and 10 µm) added to (1) the ivm medium on oocyte nuclear maturation and developmental competence of ovine oocytes, and (2) to the ivc medium on embryonic development of ovine embryos were investigated.

Comparison of photodiode nonlinearity measurement systems.

Photodiode nonlinearity measurements using one-, two- and three-tone measurement systems are compared with each other, to investigate the comparison accuracy between setups. The mathematical relationship between each setup is analyzed, and data on multiple devices are compared to find under which conditions the measurements are comparable. It is shown that the three measurement systems can be u...

متن کامل

Measurement of the thickness of an insensitive surface layer of a PIN photodiode

We measured the thickness of an insensitive surface layer of a PIN photodiode, Hamamatsu S3590-06, used in the Tokyo Axion Helioscope. We made alpha-particles impinge on the PIN photodiode in various incidence angles and measured the pulse height to estimate the thickness of the insensitive surface layer. This measurement showed its thickness was 0.31±0.02 μm on the assumption that the insensit...

متن کامل

Development of Active Pixel Photodiode Sensors for Gamma Camera Application

We designed new photodiodes sensors including current mirror amplifiers. These photodiodes have been fabricated using a CMOS 0.6 micrometers process from Austria Micro System (AMS). The Photodiode areas are respectiveley 1mm x 1mm and 0.4mm x 0.4mm with fill factor 98 % and total chip area is 2 square millimetres. The sensor pixels show a logarithmic response in illumination and are capable of ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: JSME International Journal Series A

سال: 2006

ISSN: 1344-7912,1347-5363

DOI: 10.1299/jsmea.49.282