Phenomena of built-up edges in very low speed grinding process. Very low speed grinding process. (2nd report).
نویسندگان
چکیده
منابع مشابه
Very Low-Cost In-Process Gauging System
A vision system to gauge two types of automotive parts has been developed. One of the part types is a power steering connector in which the depth and width of the groove, and the distance between the start of the groove and the end of the power steering line are gauged. For the second type of part, a crimped connector attached to a brake hose, measurements of interest are the two diameters of t...
متن کاملNew Process for Achieving Very Low Nox
Over the last two and a half years, Covanta Energy, working with their technology partner, Martin GmbH of Germany, has developed and commercialized a new technology for reducing NOx emissions from Energy from Waste (EfW) facilities. NOx levels below 60 ppm (7% O2) have been reliably achieved, which is a reduction of 70% below the current EPA standard and typical levels of today’s EfW facilities...
متن کاملStudy of Traverse Grinding Process (1st Report) Accumulation Phenomenon and Size Generation Mechanism in Traverse Grinding
plicated processes on the wheel surf ace along the wheel width. In order to make these processes clear, the experimental analysis of traverse grinding was conducted by widely changing the speed ratio, Kv, the setting depth of wheel, ‡TMT, and the number of total steps, m, (the ratio of the wheel width over the traverse feed per one revolution of the workpiece). The following results were obtain...
متن کاملATOMIC: A Low-Cost, Very-High-Speed LAN
ATOMIC is an inexpensive O(gigabit) speed LAN built by USC/ISI. It is based upon Mosaic technology developed for fine-grain, message-passing, massively parallel computation. Each Mosaic processor is capable of routing variable length packets, while providing added value through simultaneous computing and buffering. ATOMIC adds a general routing capability to the native Mosaic wormhole routing t...
متن کاملModeling of the Process of Coal Grinding
T. Wyleciał, H. Radomiak, D. Urbaniak, Częstochowa University of Technology, Czestochowa, Poland The use of coal in the steel industry, similarly as in the whole national ec onomy, is often preceded by its pre-treatment. Coal is mined in the form of big solids, but, being in such a form, it can’t be combusted, sintered, or gasifi ed. Therefore, it needs t o be appropriately grinding. In the pap...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Precision Engineering
سال: 1991
ISSN: 1882-675X,0912-0289
DOI: 10.2493/jjspe.57.479