Phase-Noise and Amplitude-Noise Measurement of DACs and DDSs
نویسندگان
چکیده
منابع مشابه
Measurement of Oscillator Phase and Amplitude Noise at W-band
This paper describes a technique used to measure oscillator noise sidebands at 94GHz. It is extendible to other frequencies in the millimetre-wave band. Oscillator noise sidebands are particularly significant for Continuous Wave (CW) radars, where the sidebands of the transmit/receive leakage can degrade the system noise figure. Measuring oscillator noise is also a particular challenge at highe...
متن کاملHigh-Dynamic-Range Laser Amplitude and Phase Noise Measurement Techniques
We describe techniques for making sensitive and high-dynamic-range measurements of laser amplitude and envelope phase noise (timing jitter) in the frequency domain at the shot-noise limit. Examples of amplitude noise measurements on continuous-wave argon-ion and diode-pumped solid-state lasers used for pumping a femtosecond Ti : sapphire laser are presented. Amplitude and phase noise measuremen...
متن کاملAdvanced interferometric phase and amplitude noise measurements
The measurement of the close-to-the-carrier noise of two-port radio frequency and microwave devices is a relevant issue in time and frequency metrology and in some fields of electronics, physics, and optics. While phase noise is the main concern, amplitude noise is often of interest. Presently the highest sensitivity is achieved with the interferometric method, that consists of the amplificatio...
متن کاملSpectral amplitude and phase noise characterization of titanium-sapphire lasers.
There are few methods capable of characterizing pulse-to-pulse noise in high repetition rate ultrafast lasers. Here we use a recently developed method, termed fidelity, to determine the spectral amplitude and phase noise that leads to lack of pulse repeatability and degrades the performance of laser sources. We present results for a titanium sapphire oscillator and a regenerative amplifier syst...
متن کاملAdvanced bridge (interferometric) phase and amplitude noise measurements
The measurement of the close-to-the-carrier noise of two-port radiofrequency and microwave devices is a relevant issue in time and frequency metrology and in some fields of electronics, physics and optics. While phase noise is the main concern, amplitude noise is often of interest. Presently the highest sensitivity is achieved with the interferometric method, that consists of the amplification ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
سال: 2020
ISSN: 0885-3010,1525-8955
DOI: 10.1109/tuffc.2019.2943390