Peritectic Structure Evolution in Hot-dip Zn-Al Alloy Coatings
نویسندگان
چکیده
منابع مشابه
DESCRIPTION OF STRUCTURE OF Fe-Zn INTERMETALIC COMPOUNDS PRESENT IN HOT-DIP GALVANIZED COATINGS ON STEEL
P. Pokorny, J. Kolisko, L. Balik – Czech Technical University – Klokner Institute, Prague, Czech Republic P. Novak – Institute of Chemical Technology, Prague, Czech Republic The article is describing formation, composition, morphology and crystallographic characteristics of intermetalic compounds Fe Zn present in the coating formed during the process of low-temperature hot-dip galvanizing of ca...
متن کاملMicrostructural Evolution and Dynamic Softening Mechanisms of Al-Zn-Mg-Cu Alloy during Hot Compressive Deformation
The hot deformation behavior and microstructural evolution of an Al-Zn-Mg-Cu (7150) alloy was studied during hot compression at various temperatures (300 to 450 °C) and strain rates (0.001 to 10 s-1). A decline ratio map of flow stresses was proposed and divided into five deformation domains, in which the flow stress behavior was correlated with different microstructures and dynamic softening m...
متن کاملFormation oF outburst struCturE in hot dip galvannEalEd Coatings on iF stEEls
Rapid development of automotive industry brings also increased requirements for sheets properties, involving relatively high strength and good formability together with excellent corrosion resistance. Increasing requests for corrosion resistance lead to the production of coated car parts, protected mainly by zinc coatings. Whereas, majority of European producers of passenger cars use preferenti...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 2020
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane.tetsu-2019-107