Performance improvement of shell and tube heat exchanger by using Fe3O4/water nanofluid

نویسندگان

چکیده

The objective of this paper is to study the effect nanofluid on performance heat exchanger, as well transfer rate, coefficient total transfer, friction influence and average Nusselt number, thermal efficiency factor has been investigated discussed. In work, output Fe3O4/water through shell tube exchanger numerically under laminar flow. CFD simulations with ANSYS FLUENT 2020R1 were used adopting finite volume approach solve governing equations. Numerical calculations carried out for Reynolds numbers ranging from 200 1400, nanoparticles fraction (0.2% 0.35%). results show that augmentation in increase number amount rate at concentration 0.35% are approximately 19%, 25% 12% respectively. It was observed decreases increase.

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Economic Optimization of Shell and Tube Heat Exchanger Using Nanofluid

Economic optimization of shell and tube heat exchanger (STHE) is presented in this paper. To increase the rate of heat transfer, copper oxide (CuO) nanoparticle is added into the tube side fluid and their optimum results are compared with the case of without additive nanoparticle. Total annual cost (TAC) is selected as fitness function and nine decision variables related to the heat exchanger p...

متن کامل

Effect of baffle oientation on shell tube heat exchanger performance

In this paper, fluid flow and heat transfer in the laboratory (small size) shell tube heat exchanger are analysed by computational fluid dynamic software. In this type of shell tube heat exchanger baffles with different angles of rotation: 00 (horizontal segmental baffle), 150 (from horizontal), 300, 450, 600, 750, 900 (vertical segmental baffle) is used. Effect of baffle orientation on shell t...

متن کامل

Analysis of Gasketed-plate Heat Exchanger Performance Using Nanofluid

A heat exchanger using nanofluid needs to operate at optimum mass concentration level to get the maximum heat transfer performance. A numerical analysis is performed on the heat transfer and pressure drop of water-based γ-Al2O3 nanofluid gasketed-plate heat exchanger to specify its optimum conditions. Cold water will be heated by γ-Al2O3/water nanofluid. The results showed that optimal volume c...

متن کامل

Thermal Analysis of Shell-Side Flow of Shell-and-Tube Heat Exchanger Using Experimental and Theoretical Methods

In this paper the thermal behavior of the shell-side flow of a shell-and-tufe heat exchanger has been studied using theoretical and experimental methods. The experimental method Provided the effect of the major parameters of the shell-side flow on thermal energy exchange. In the numerical method, besides the effect of the major paramerers, the effect of different geometric parameters and Re on ...

متن کامل

Thermal-Economic Optimization of Shell and Tube Heat Exchanger by using a new Multi-Objective optimization method

Many studies are performed by researchers about Shell and Tube Heat Exchanger but the Multi-Objective Big Bang-Big Crunch algorithm (MOBBA) technique has never been used in such studies. This paper presents application of Thermal-Economic Multi-Objective Optimization of Shell and Tube Heat Exchanger Using MOBBA. For optimal design of a shell and tube heat exchanger, it was first thermally model...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Thermal Engineering

سال: 2023

ISSN: ['2148-7847']

DOI: https://doi.org/10.18186/thermal.1239793