Performance Evaluation of GFRP Rock Bolt Sensor for Rock Slope Monitoring by Double Shear Test
نویسندگان
چکیده
منابع مشابه
Numerical Investigation of Effect of Rock Bolt Angle on Shear Behavior of Rock Bridges
In this work, the effect of rock bolt angle on the shear behavior of Rock Bridges is investigated using the particle flow code in two dimensions (PFC2D) for three different Rock Bridge lengths. Firstly, the calibration of PF2D is performed to reproduce the gypsum sample. Then the numerical models with the dimensions of 100 mm * 100 mm are prepared. The Rock Bridge is created in the middle of th...
متن کاملA Review of Rock Bolt Monitoring Using Smart Sensors
Rock bolts have been widely used as rock reinforcing members in underground coal mine roadways and tunnels. Failures of rock bolts occur as a result of overloading, corrosion, seismic burst and bad grouting, leading to catastrophic economic and personnel losses. Monitoring the health condition of the rock bolts plays an important role in ensuring the safe operation of underground mines. This wo...
متن کاملAnalytical Design of Rock - Bolt Systems
1.INTRODUCTION Some forty years ago, most opening supports and reinforcements were designed using empirical rules defining ground loads acting on the supporting structures. This approach is still popular and interest in it has been renewed by the use of rock mass classification systems (Barton et al. 1974, Bieniawski, 1974,1976,1989). Correlations between rock mass conditions and the type of su...
متن کاملRock Bolt Inspection by Means of RBT Instrument
In this paper we present a new digital ultrasonic instrument for nondestructive inspection of rock bolts using guided waves. The Rock Bolt Tester (RBT) instrument applies long-range ultrasound to investigate bolt’s status, especially its grouting condition. RBT features an application tailored ultrasound probe that transmits high-energy, low frequency (below 100kHz) guided waves and is capable ...
متن کاملBack analyses for slope failures in rock
Some of the geotechnical parameters used in the analysis may not be accurately measured directly from laboratory tests due to effects of sample disturbance and errors of tests. The back analysis or the observational method are thus often applied to determine the representative and/or dominant strength parameters based on field observations in practice. Based on the Hoek-Brown failure criterion,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Civil Engineering
سال: 2020
ISSN: 1687-8086,1687-8094
DOI: 10.1155/2020/8870698