Performance Analysis of the Milk Pasteurization Process Using a Flat Plate Solar Collector
نویسندگان
چکیده
A large share of Ethiopia’s milk production comes from its rural areas. However, this does not undergo further processing into dairy products on a scale due to lack conventional energy sources such as electricity and gas. Hence, the country is utilizing resources maximum possible. In study, possible use solar for pasteurization process investigated by using flat plate collector (FPSC) with without reflectors integrated. Reflectors added FPSC have augmented incident radiation 0.27–0.91 kW/m2 0.36–1.18 kW/m2. The thermal efficiency obtained integrated 51.8% whereas that 46.2%. Likewise, exergy found be 5.43% 2.53% reflectors. Also, an increase in daily processed 18% observed September 16% November quality pasteurized checked methylene blue reduction test (MBRT) method, it indicates better when compared raw milk. Therefore, study shows has great potential shelf life milk, can used instrument improve people living
منابع مشابه
Sensitivity Analysis of the Test Parameters of a Solar Flat Plate Collector for Performance Studies
The BIS test procedure for performance of solar flat plate collectors allows a certain limit of deviation for the control parameters to define the steady state condition. During actual performance studies, sometimes these limits are exceeded. In this paper an attempt has been made to find out the effect on the performance curve of the collector as a result of exceeding this prescribed limit by ...
متن کاملexergy analysis of a flat plate solar collector in combination with heat pipe
the use of solar collectors in combination with heat pipes is rapidly growing in recent years.heat pipes, as heat transfer components, have undeniable advantages in comparison with other alternatives. the most important advantage is their high rate of heat transfer at minor temperature differences. although there have been numerous studies on the heat analysis or first thermodynamic analysis of...
متن کاملModeling of Flat-Plate Solar Collector Operation in Transient States
Saleh, Ahmad M. M.S.E., Purdue University, May 2012. Modeling Of Flat-Plate Solar Collector Operation in Transient States. Major Professor: Hosni Abu-Mulaweh. Solar energy is becoming an alternative for the limited fossil fuel resources. One of the simplest and most direct applications of this energy is the conversion of solar radiation into heat, which can be used in water heating systems. A c...
متن کاملThe Possibility of using Flat Plate Solar Collector Based on the Best Calculated Tilt Angle in the City of Rasht as a Case Study (TECHNICAL NOTE)
The possibility of using flat plate collector in northern parts of Iran specially city of Rasht has been investigated in this paper. According to the high humidity in the northern parts of this country, diffuse radiation plays a more important role than direct radiation. This fact can change the results of delivered solar energy and the best tilt angle of the collector compared to the sunny cen...
متن کاملEnergy, economic and environmental analysis of metal oxides nanofluid for flat-plate solar collector
For a solar thermal system, increasing the heat transfer area can increase the output temperature of the system. However, this approach leads to a bigger and bulkier collector. It will then increase the cost and energy needed to manufacture the solar collector. This study is carried out to estimate the potential to design a smaller solar collector that can produce the same desired output temper...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of engineering
سال: 2022
ISSN: ['2314-4904', '2314-4912']
DOI: https://doi.org/10.1155/2022/6214470