Perfluorosulfonic Acid Membrane for Lithium–Sulfur Batteries with S/C Cathodes

نویسندگان

چکیده

Polymer electrolyte based on Nafion-117 membranes in the Li+ form with intercalated 1,3-dioxolane-dimethoxyethane solvent mixtures (DOL-DME) has been obtained. The obtained Nafion-Li+-DOL-DME characterized by DSC analysis, IR- and impedance spectroscopy. uptake of membrane DOL-DME mixture amounts to 1.9. is an ionic conductivity ~10−7 S cm−1 at room temperature. comparative study electrochemical properties Li–S batteries liquid (1M Li(CF3SO2)2N DOL-DME) polypropylene film (PP) or S/C composites mesoporous carbon as cathode materials shown that use can improve cyclability cell. first-cycle discharge capacities electrodes battery cells PP were 730 450 mAh g−1, respectively (0.1 mV s−1). However, capacity cell reduced significantly after 10 cycles. exhibits enhanced cyclability. 365 g−1 cycles up 290 40

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Molecular modeling of the short-side-chain perfluorosulfonic acid membrane.

Presented here is a first principles based molecular modeling investigation of the possible role of the side chain in effecting proton transfer in the short-side-chain perfluorosulfonic acid fuel cell membrane under minimal hydration conditions. Extensive searches for the global minimum energy structures of fragments of the polymer having two pendant side chains of distinct separation (with che...

متن کامل

Copper-Stabilized Sulfur-Microporous Carbon Cathodes for Li–S Batteries

wileyonlinelibrary.com interact with two Li atoms per S atom, the S cathode can provide reversible high capacity of 1675 mAh g -1 at average potentials of 2.0 V, [ 1–3 ] which is 10× higher energy density than that of classical commercial LiCoO 2 cathode. Since the capacity of current LiCoO 2 -graphite Li-ion battery is controlled by LiCoO 2 cathode, replacement of expensive LiCoO 2 with cheap ...

متن کامل

Li2MnSiO4 Nanostructured Cathodes for Rechargeable Lithium-Ion Batteries

Rechargeable lithium-ion battery technology dominates the portable electronics market following the rapid growth in demand since the introduction of the first, commercial lithium-ion battery by Sony in 1990 [1]. Motivated by concerns for global warming and environmental degradation, researchers have focused on extending the use of rechargeable lithium-ion batteries to large-scale applications. ...

متن کامل

Harovel G. Wheat MANGANESE OXIDE CATHODES FOR RECHARGEABLE BATTERIES

Dedicated To my wife, Dohee Kwon v Acknowledgement First of all, I would like to express my deep gratitude to my advisor, Dr. Arumugam Manthiram, for having guided me to finish my research successfully and provided me precious support and constant encouragement. Without his support, it would have taken much longer to finish my work.

متن کامل

Doped LiFePO4 Cathodes for High Power Density Lithium Ion Batteries

Olivine LiFePO4 has received much attention recently as a promising storage compound for cathodes in lithium ion batteries. It has an energy density similar to that of LiCoO 2, the current industry standard for cathode materials in lithium ion batteries, but with a lower raw materials cost and an increased level of safety. An inherent limitation of LiFePO4 acknowledged by researchers studying t...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Batteries

سال: 2022

ISSN: ['2313-0105']

DOI: https://doi.org/10.3390/batteries8100162