Pengaruh Suhu Dan Persentase Reduksi Terhadap Limit Drawing Ratio (LDR) Pada Proses Metal Forming Paduan 70Cu-30Zn [Effect of Temperature and Reduction Percentage to Limit Drawing Ratio (LDR) on Metal Forming of 70Cu-30Zn Alloy]
نویسندگان
چکیده
منابع مشابه
extra high limiting drawing ratio (ldr=9) cylindrical deep drawing based on finite element and experiment
deep drawing of cylindrical shapes with high limiting drawing ratio (ldr) values is relatively difficult. annealing is a further operation, which in turn adds costs and consumes significantly time to the forming process. in the present work, cylindrical cups from brass sheet were made with only limited anneal during few steps, but having ldr of 9 that is about 2 times higher than previous works...
متن کاملForming of Multi layer Sheet Metal by Drawing Process: an Analysis and FEM Simulation
In this paper, the drawing process of multi-layer sheet metal through wedge shaped die has been analyzed using stream function and upper bound method. Typically a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and ou...
متن کاملAnalysis of deep drawing process to predict the forming severity considering inverse finite element and extended strain-based forming limit diagram
An enhanced unfolding Inverse Finite Element Method (IFEM) has been used together with an extended strain-based forming limit diagram (EFLD) to develop a fast and reliable approach to predict the feasibility of the deep drawing process of a part and determining where the failure or defects can occur. In the developed unfolding IFEM, the meshed part is properly fold out on the flat sheet and tre...
متن کاملEffect of different yield functions on computations of forming limit curves for aluminum alloy sheets
In this article, the effect of different yield functions on prediction of forming limit curve (FLC) for aluminum sheet is studied. Due to importance of FLC in sheet metal forming, concentration on effective parameters must be considered exactly in order to have better theoretical prediction comparing experimental results. Yield function is one of the factors which are improved by adding new coe...
متن کاملNumerical Determination of the Forming Limit Diagram for 304 Stainless Steel Based on Phase Change in Deep Drawing Process
Up to now a large number of models have been developed to measure or predict the damage in equipments. Some of these models have been implemented in ABAQUS software. To implement damage parameters in the software, it is necessary to perform complex and expensive practical tests. One of these damage models is Forming Limit Diagram (FLD).The purpose of this research is deriving required parameter...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metalurgi
سال: 2016
ISSN: 2443-3926,0126-3188
DOI: 10.14203/metalurgi.v31i2.126