Pengaruh Anneal Hardening Dan % Reduksi Warm Rolling Terhadap Sifat Mekanik Paduan Cu-Zn 70/30 [Influence of Anneal Hardening And Warm Rolling % Reduction To Mechanical Properties of Cu-Zn 70/30]

The Anneal Hardening and Deformation Softening Behaviors of Nanocrystalline Cu-Zn Alloys

The changes in the mechanical properties and microstructure of nanocrystalline Cu-Zn alloys deformed by cryorolling during low temperature annealing and the post-process deformation were studied. The deformed Cu-Zn alloys exhibited uncommon anneal hardening and deformation softening behaviors. The degree of anneal hardening and deformation softening increased with the addition of the solute ato...

INFLUENCE OF LASER SURFACE HARDENING ON CORROSION PROPERTIES OF Al-Zn-Si CAST ALLOY

E. Tillová, L. Kuchariková, M. Chalupová, J. Belan, A. Vaško, I. Švecová, University of Žilina, Faculty of Mechanical Engineering, Slovak Republic This work is focused on the effect of the laser surface treatment (laser power 50 and 80 W) on microstructure and corrosion properties of self-hardened AlZn10Si8Mg cast alloy used for engine and vehicle constructions. The electrochemical impedance sp...

ANELASTIC EFFECTS IN SINGLE CRYSTALS OF -Cu-Zn AND -Cu-Zn-Al ALLOYS

Characterization of calf liver Cu,Zn-metallothionein: naturally variable Cu and Zn stoichiometries.

Cu,Zn-metallothioneins were purified from bovine calf liver in order to examine the stoichiometry of metal binding to the protein. Copper and zinc analyses were carried out by atomic absorption spectrophotometry. Consistent quantitative thiolate analyses were obtained spectrophotometrically with Ellman's reagent and amperometrically with phenylmercuric acetate. These were used to define protein...

Electrodeposition of Zn, Cu, and Zn-Cu Alloys from Deep Eutectic Solvents

Deep eutectic solvents (DESs) comprising choline chloride (ChCl) with either urea or ethylene glycol (EG) have been successfully used as powerful and potential electrolytes for extracting metals from their corresponding metal oxide precursors. In this work, for electrodeposition of Zn and Zn-Cu alloys, ChCl/urea-based DES was employed. Cyclic voltammetry study demonstrates that the reduction of...