PCM thermal control unit for portable electronic devices: experimental and numerical studies
نویسندگان
چکیده
منابع مشابه
An experimental assessment of nanostructured materials embedded in a PCM-based heat sink for transient thermal management of electronic
In the present paper, an experimental assessment was performed on the transient thermal performance of a heat sink filled by a phase change material (PCM) and PCM embedded with carbon nanofibers (CNFs) and titania (TiO2) nanoparticles as nanostructured materials. In order to enhance the thermal conductivity of PCM, CNFs and TiO2 nanoparticles at different loadings (0.5wt. % and 2 wt.% of CNFs a...
متن کاملsimulation and experimental studies for prediction mineral scale formation in oil field during mixing of injection and formation water
abstract: mineral scaling in oil and gas production equipment is one of the most important problem that occurs while water injection and it has been recognized to be a major operational problem. the incompatibility between injected and formation waters may result in inorganic scale precipitation in the equipment and reservoir and then reduction of oil production rate and water injection rate. ...
Simulation, Control and Experimental Analysis of 1,3Butadiene Purification Unit
Simulation of a process and analysis of its resulting data in both dynamic and steady-state conditions are fundamental steps in understanding the process in order to design and efficient control of system as well as implementing operational cost reduction scheme. In the present paper, steady and unsteady state simulation of Amir Kabir1, 3 butadiene purification units has been done by using Aspe...
متن کاملNumerical and Experimental Investigation of Thermal Debinding
Powder injection molding (PIM) is an important netshape manufacturing process and has received much attention. One of the most critical steps in PIM process is debinding. It consumes a major part of the processing time. Failure of the powder compact often results if the process is accelerated. Thermal debinding is a common methodology for the final removal of residual polymer from a PIM compact...
متن کاملHigh-speed scanning thermal lithography for nanostructuring of electronic devices.
We report a detailed analysis on the use of simultaneous substrate heating in conjunction with scanning thermal lithography (SThL) to dramatically increase the patterning speed of conventional SThL systems. The investigation consists of finite element simulations as well as practical assessments of the speed at which different organic precursors are thermally converted to produce standalone ele...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Components and Packaging Technologies
سال: 2003
ISSN: 1521-3331
DOI: 10.1109/tcapt.2003.811480