PC Configuration and Component Recommendation System
نویسندگان
چکیده
منابع مشابه
Implementing a PC Hardware Configuration (BIOS) Baseline
High level operating system features such as patch management, full disk encryption, virtualization, and malware protection are increasingly reliant on properly configured Basic Input Output System (BIOS) firmware settings and support. Varying configuration settings complicate the implementation process and subsequent troubleshooting sessions. This paper presents a solution to these issues thro...
متن کاملComponent Configuration Management
Component-based programming is now a widely recognized approach in software development. There remain many open problems related to both technical and non-technical aspects of the components. In this paper, we point out the problem of component identification. Since the components are usually binary units deployed in the system at run-time, we do not have the same insight into their characteris...
متن کاملPluggable Component: A Pattern for Interactive System Configuration
In many applications, especially in frameworks, it is necessary to exchange components. The standard approach to achieve this is to use an abstract class as the interface against which the application is programmed, and several concrete subclasses to supply implementations for the abstract interface class. There are several GOF patterns that deal with this kind of component exchange (see Relate...
متن کاملA Configuration Management System Supporting Component-Based Software Development
Component-based software development has been viewed as an emerging paradigm of software development. This paper analyzes the requirements of configuration management in component-based development process. Based on the analysis, a prototype configuration management system is proposed to meet the requirements. An example of using the system is also given.
متن کاملAutomatic PC disassembly for component recovery
In this article, a personal computer disassembly cell is presented. With this cell, a certain degree of automatism is afforded for the non-destructive disassembly process and for the recycling of these kinds of mass-produced electronic products. Each component of the product can be separated. The disassembly cell is composed of several sub-systems, each of which is dedicated to the planning and...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Computer Applications
سال: 2021
ISSN: 0975-8887
DOI: 10.5120/ijca2021921411