Particle size, volume fraction and matrix strength effects on fatigue behavior and particle fracture in 2124 aluminum-SiCp composites
نویسندگان
چکیده
منابع مشابه
Particle size, volume fraction and matrix strength effects on fatigue behavior and particle fracture in 2124 aluminum-SiCp composites
The effects of particle size, volume fraction and matrix strength on the stress-controlled axial fatigue behavior and the probability of particle fracture were evaluated for 2124 aluminum alloy reinforced with SiC particles. Average particle sizes of 2, 5, 9 and 20/~m and volume fractions of 0.10, 0.20 and 0.35 were examined for four different microstructural conditions. Tensile and yield stren...
متن کاملFatigue crack growth resistance in SiC particulate and whisker reinforced P/M 2124 aluminum matrix composites
Fatigue crack growth is examined in P/M 2124 aluminum alloys reinforced with SiC particles (SiCp) and whiskers (SiCw) over a wide spectrum of growth rates from 10 to 10 m per cycle. Effects of aging treatment, orientation of crack growth direction with respect to the rolling direction, mean stress (or stress ratio), and reinforcement volume percent on the fatigue crack growth threshold are inve...
متن کاملEffect of particle size and volume fraction on tensile properties of fly ash/polyurea composites
Fly ash, which consists of hollow particles with porous shells, was introduced into polyurea elastomer. A one-step method was chosen to fabricate pure polyurea and the polyurea matrix for the composites based on Isonate® 2143L (diisocyanate) and Versalink® P-1000 (diamine). Scanning electron microscopy was used to observe the fracture surfaces of the composites. Particle size and volume fractio...
متن کاملSoldering of Aluminum Matrix Composites Sicp/a356 and Kovar Alloy
Article history: Received 28.3.2013 Received in revised form 26.4.2013 Accepted 29.4.2013 Aluminum matrix composites containing 55% SiC particle reinforcing phase/SiC reinforcement phase particle and Kovar alloy 4J29 were chosen as the base metals. After nickel plating on the surface of SiCp/Al, two kinds of materials were soldered together by using Zn-Cd-Ag-Cu as the filler metal and ZnCl2 as ...
متن کاملEffects of particle size, particle/matrix interface adhesion and particle loading on mechanical properties of particulate–polymer composites
There have been a number of review papers on layered silicate and carbon nanotube reinforced polymer nanocomposites, in which the fillers have high aspect ratios. Particulate–polymer nanocomposites containing fillers with small aspect ratios are also an important class of polymer composites. However, they have been apparently overlooked. Thus, in this paper, detailed discussions on the effects ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science and Engineering: A
سال: 1994
ISSN: 0921-5093
DOI: 10.1016/0921-5093(94)90891-5