Particle-size distribution of alumina slag after grinding

نویسندگان

چکیده

The paper considers the issues of energy consumption and effectiveness using aluminous slag as an expansion agent compared to Portland cement. Aluminous is a difficult material grind, but its use additive in demand for building materials. following research methods were used: grinding materials, sieve analysis, electron microscopy. According results studies, it was found that effective

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Compressibility and Foaming behavior of steel slag/waste glass compositesby particle size distribution and foam agents

In present research, the foam glass-ceramic composites fabricated by window glass, steel slag and SiC, CaCO3 foaming agents were investigated by press–sintering method. The optimum sintering temperature was obtained at 1200°C with a 3-minutes holding time and 20°C/min heating rate. The optimum pressure level of 80 MPa for achieving the 70 % of relative density was selected. The effec...

متن کامل

Densification characteristics of chromia/alumina castables by particle size distribution

The quality of the refractories applied on integrated gasification combined cycle should be a key factor that affects both the reliability and the economics of gasifier operation. To enhance the workability of chromia/alumina castables, three types of ultrafine alumina powder were added to improve the workability. Densification behavior of such castables in the presence of ultrafine alumina was...

متن کامل

effect of grinding method on energy consumption and particle size distribution of blended cements

the benefits of using mineral admixtures as a partial replacement of portland cement (pc) are well established in the literature. economic and environmental advantages by reducing co2 emissions are well known. this paper examines the influence of intergrinding and separate grinding on the amount of energy consumption, blaine fineness and particle size distribution (psd) of blended cements, name...

متن کامل

Katja Ohenoja PARTICLE SIZE DISTRIBUTION AND SUSPENSION STABILITY IN AQUEOUS SUBMICRON GRINDING OF CaCO3 AND TiO2

During the past decade submicron and nanoparticles have aroused a wide interest and gained new applications due to their high surface area and strength. Grinding with a wet stirred media mill is usually the last process step before the submicron or nanoparticles are added to an application, and the step where the final particle size distribution is achieved. Since stirred media milling is an en...

متن کامل

The Control of Particle Size Distribution for Fabricated Alumina Nanoparticles Using a Thermophoretic Separator

The control of particle size distribution of fabricated alumina nanoparticles from general alumina that has a large geometric standard deviation (GSD) is studied. A thermophoretic separator was used to control the GSD of the fabricated alumina nanoparticles. Unevaporated particles and primary particles were separated to yield a small GSD for fabricated alumina nanoparticles. The fabricated alum...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: E3S web of conferences

سال: 2023

ISSN: ['2555-0403', '2267-1242']

DOI: https://doi.org/10.1051/e3sconf/202340212015