Particle size and fraction required to stabilise aluminium alloy foams created by gas injection
نویسندگان
چکیده
منابع مشابه
Aluminium Alloy Foams: Production and Properties
Ultra-light metal foams became an attractive research field both from the scientific and industrial applications view points. Closed-cell metal foams, in particular aluminium alloy (Al-alloy) ones can be used as lightweight, energy-absorption and damping structures in different industrial sectors, detaining an enormous potential when transportation is concerned. Despite the several manufacturin...
متن کاملEffects of Temperature and Particle Size Distribution on Barite Reduction by Carbon monoxide Gas
In this research, a mineral barite powder was reduced by carbon monoxide gas and the effects of reduction time and temperature was investigated as well as barite particle size. Results showed that the best result would be feasible when the barite particle sizes are between (-70 +100) in mesh scale. The barite reduction could reach the maximum level (98%) after reduction by carbon monoxide at 85...
متن کاملconsequence analysis of the leakage, ignition and explosion during high pressure sour gas injection process to the oil reservoir
there is no doubt that human being needs to become integrated with industry and industry needs to be progressed, daily. on the other hand, serious events in industrial units specially in oil industries has been shown that such damages and events are industry related ones. the consequence of such events and damages which resulted in chemical and poisoned explosions and loss of life and property ...
TENSILE AND FRACTURE CHARACTERISTICS OF A SIC- PARTICLE-REINFORCED 7075 ALUMINIUM ALLOY
Fracture behavior of a 7075 aluminium alloy reinforced with 15 Vol%. SiC particles was studied after T6 and annealing heat treatments under uniaxial tensile loading at room temperature. The scanning electron microscopy of fractured surfaces and EDS analysis showed:, that fracture mechanism changed from due mainly to fractured particle in T6 condition to interface decohesion in samples in anneal...
متن کاملBending Stiffness of Aluminium Foams
The basic manufacturing processes of cellular materials have been briefly noted as well as the metal foam properties. The most widely used are the aluminium foams due to the following properties: very good insulation (thermal insulation and sound absorption), low density (mass), high specific rigidity in sandwich structures, very good impact damping, corrosion resistance, non-flammability, very...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Scripta Materialia
سال: 2018
ISSN: 1359-6462
DOI: 10.1016/j.scriptamat.2018.04.041