Partial Safety Factors of Limit State Design
نویسندگان
چکیده
منابع مشابه
Calibration of partial safety factors for offshore foundation design
The foundation of an offshore installation is designed to resist the static and dynamic loads it is subjected to during its lifetime. The design codes specify combinations of load factor on the static load, load factor on the dynamic load, and resistance factor on the soil resistance, with reference to the ‘characteristic’ loads acting on the foundation and the ‘characteristic’ foundation capac...
متن کاملMechanism design with partial state verifiability
We study implementation in environments where agents have limited ability to imitate others. Agents are randomly and privately endowed with type-dependent sets of messages. So sending a message becomes a partial proof regarding type. For environments where agents can send any combination of available messages, we develop an Extended Revelation Principle and characterize the incentive constraint...
متن کاملService limit state resistance factors for drilled shafts
The analysis of bored piles, or drilled shafts, at the service limit state is important when foundation settlements are critical to the operation of a structure. The t–z method is a widely used soil–structure interaction model for the analysis of drilled shaft settlement. In current practice, nominal values of soil stiffness and strength parameters are used to determine settlement based upon th...
متن کاملDesign, Analysis and Experience of a Partial state router
In this paper, we motivate the use of partial state schemes in a wide variety of network applications. Partial state can be used to arrive at a list of high bandwidth flows which can be made use of in containing nonresponsive flows, providing better QoS for web traffic, and alleviate certain Denial of Service (DoS) attacks. We show the practical feasibility of partial state based schemes by imp...
متن کاملAccidental Limit State of Submarine Pipeline: Trawl Gears Pull-Over Loads and Effect of Free Span
Submarine pipelines failures lead to oil spills in water and may even lead to explosions with heavy financial and environmental damages. Trawl gear is one of the main factors in the failure of the submarine pipelines. In this paper, sensitivity analysis is performed on influence of height and span length alternations on the response of pipeline against the traction caused by trawling pull-over ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Concrete Research and Technology
سال: 1991
ISSN: 1340-4733
DOI: 10.3151/crt1990.2.2_107