Parameters of protective carbon films applied on high-speed steels M42 via magnetronic sputtering

Secondary Hardening in High Speed Steels

Effects of Austenitizing Conditions on the Microstructure of AISI M42 High-Speed Steel

The influences of austenitizing conditions on the microstructure of AISI M42 high-speed steel were investigated through thermodynamic calculation, microstructural analysis, and in-situ observation by a confocal scanning laser microscope (CSLM). Results show that the network morphology of carbides could not dissolve completely and distribute equably in the case of the austenitizing temperature i...

Exploring the potential of high power impulse magnetron sputtering for growth of diamond-like carbon films

Amorphous carbon films are deposited employing high power impulse magnetron sputtering (HiPIMS) at pulsing frequencies of 250 Hz and 1 kHz. Films are also deposited by direct current magnetron sputtering (dcMS), for reference. In both HiPIMS and dcMS cases, unipolar pulsed negative bias voltages up to 150 V are applied to the substrate to tune the energy of the positively charged ions that bomb...

Carbide Structure and Fracture Toughness of High Speed Tool Steels

In the present study, M2 high speed steels were fabricated by using electro-slag rapid remelting process. Carbide structure was analysed and the fracture toughness and hardness were also measured after austenitization treatment at 1190 and 1210C followed by tempering treatment at 535C for billets with various diameters from 16 to 60 mm. Electro-slag rapid remelting (ESRR) process is an advanced...

Influence of inert gases on the reactive high power pulsed magnetron sputtering process of carbon-nitride thin films