Parameter Optimization of Electro-Discharge Machining (EDM) in AISI D2 Die Steel using Taguchi Technique
نویسندگان
چکیده
منابع مشابه
Performance Evaluation of Powder Metallurgy Electrode in Electrical Discharge Machining of AISI D2 Steel Using Taguchi Method
In this paper an attempt has been made to correlate the usefulness of electrodes made through powder metallurgy (PM) in comparison with conventional copper electrode during electric discharge machining. Experimental results are presented on electric discharge machining of AISI D2 steel in kerosene with copper tungsten (30% Cu and 70% W) tool electrode made through powder metallurgy (PM) techniq...
متن کاملMulti-objective optimisation of die sinking electro discharge machining process using Taguchi
The objective of this paper is to determine the optimal setting of the process parameters on the electro-discharge machining (EDM) machine while machining AISI H13 tool steel. The parameters considered are pulse current, pulse-on-time, pulse-off-time and gap voltage ; whereas the responses are Tool wear ratio (TWR) and material removal rate (MRR). The optimal setting of the parameters are deter...
متن کاملFatigue Life of Graphite Powder Mixing Electrical Discharge Machining AISI D2 Tool Steel
The present paper deals with the design of experimental work matrices for two groups of experiments by using Response surface methodology (RSM). The first EDM group was dealt with the use of kerosene dielectric alone, while the second was treated by adding the graphite micro powders mixing to dielectric fluid (PMEDM). The total heat flux generated and fatigue lives after EDM and PMEDM models we...
متن کاملOn machining of hardened AISI D2 steel with PCBN tools
This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life...
متن کاملOptimization of Process Parameters in Turning of AISI 8620 Steel Using Taguchi and Grey Taguchi Analysis
The aim of this research is to investigate the optimization of cutting parameters (cutting speed, feed rate and depth of cut) for surface roughness and metal removal rate in turning of AISI 8620 steel using coated carbide insert. Experiments have been carried out based on Taguchi L9 standard orthogonal array design with three process parameters namely cutting speed, feed rate and depth of cut f...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Indian Journal of Science and Technology
سال: 2016
ISSN: 0974-5645,0974-6846
DOI: 10.17485/ijst/2016/v9i43/101972