Output-Only Damage Detection of Steel Beam Using Moving Average Filter
نویسندگان
چکیده
منابع مشابه
Multi-Damage Detection for Steel Beam Structure
Damage detection has been focused by researchers because of its importance in engineering practices. Therefore, different approaches have been presented to detect damage location in structures. However, the higher the accuracy of methods is required the more complex deliberations. Based on the conventional studies, it was observed that the damage locations and its size are associated with dynam...
متن کاملOutput-only Modal Analysis of a Beam Via Frequency Domain Decomposition Method Using Noisy Data
The output data from a structure is the building block for output-only modal analysis. The structure response in the output data, however, is usually contaminated with noise. Naturally, the success of output-only methods in determining the modal parameters of a structure depends on noise level. In this paper, the possibility and accuracy of identifying the modal parameters of a simply supported...
متن کاملDamage Detection in Beam-like Structures using Finite Volume Method
In this paper the damage location in beam like-structure is determined using static and dynamic data obtained using finite volume method. The change of static and dynamic displacement due to damage is used to establish an indicator for determining the damage location. In order to assess the robustness of the proposed method for structural damage detection, three test examples including a static...
متن کاملCorner point detection using nest moving average
Corners are rich in high frequency components. A low-pass filter suppresses corners and results in a smooth curve. Therefore, corner points have a larger amount of shift than other points and can easily be detected by a low-pass filter. Experiments suggest that a moving average can do this job suitably with a low computational load and good locality in spatial domain. A moving average with a sm...
متن کاملDamage Detection of Bridge Beam Structures under Moving Loads
System identification technique is used widely in the damage assessment of engineering structures. It is regarded as the key part of a structural health monitoring system, which identifies the physical parameters from the raw measurement data. The changes in the identified parameters will be used to assess the damage of the structure. Most system identification methods need the input loading an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Shock and Vibration
سال: 2018
ISSN: 1070-9622,1875-9203
DOI: 10.1155/2018/2067680