Orthogonal Cutting Process Modelling Considering Tool-workpiece Frictional Effect
نویسندگان
چکیده
منابع مشابه
Effect of cutting parameters on tool-chip interface temperature in an orthogonal turning process
The aim of this paper is to investigate the effect of cutting speed and uncut chip thickness on cutting performance. A Finite Element Method (FEM) based on the ABAQUS explicit software which involves Johnson-Cook material mode and Coulombs friction law was used to simulate of High Speed Machining (HSM) of AISI 1045 steel. In this simulation work, feed rate ranging from 0.05 mm/rev to 0.13 mm/re...
متن کاملModeling of Cutting Forces Under Hard Turning Conditions Considering Tool Wear Effect
Quantitative understanding of cutting forces under hard turning conditions is important for thermal modeling, tool life estimation, chatter prediction, and tool condition monitoring purposes. Although significant research has been documented on the modeling of forces in the turning operation in general, turning of hardened materials involves several distinctive process conditions, including neg...
متن کاملDetermination of workpiece flow stress and friction at the chip–tool contact for high-speed cutting
This paper presents a methodology to determine simultaneously (a) the flow stress at high deformation rates and temperatures that are encountered in the cutting zone, and (b) the friction at the chip–tool interface. This information is necessary to simulate high-speed machining using FEM based programs. A flow stress model based on process dependent parameters such as strain, strain-rate and te...
متن کاملThe Orthogonal Machining Process Using Cutting Tools with Different Geometry
This paper deals with modelling of the orthogonal machining process using tools with different geometries. The finite element method (FEM) is used for a simulation based on the Lagrangian formulation including ANSYS/LS-DYNA software. The constitutive Johnson – Cook material model regarding strain, strain rate and temperature to predict material plasticity and chip separation is used. Chip morph...
متن کاملCutting Forces in Hard Turning Comprising Tool Flank Wear and Its Implication for the Friction between Tool and Workpiece
Original scientific paper In this paper, the orthogonal cutting force model is proposed comprising forces due to flank wear in addition to the forces for chip formation during the hard turning of round bar made of steel 60WCrV7 hardened at 55+2HRc. Cutting force model includes two tool conditions: perfectly sharp tool with VBB = 0 and tool with maximum permissible flank wear VBBmax. Based on cu...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia CIRP
سال: 2015
ISSN: 2212-8271
DOI: 10.1016/j.procir.2015.03.033