Optimum Rotation Speed for the Friction Stir Welding of Pure Copper
نویسندگان
چکیده
منابع مشابه
Retracted: Optimum Rotation Speed for the Friction Stir Welding of Pure Copper
This paper [1] has been retracted as it is essentially identical in content with the published article " Elucidating of rotation speed in friction stir welding of pure copper: Thermal modeling " published in References [1] M. Jabbari and C. C. Tutum, " Optimum rotation speed for the friction stir welding of pure copper, "
متن کاملSimulation of Tool Rotation and Travelling Speed Effects on Friction Stir Welding of Ti-6Al-4V
In this research, the effects of parameters include tool rotational and traverse speeds were investigated on heat generation and material flow during friction stir welding of Ti-6Al-4V alloy with computational fluid dynamics (CFD) method. Simulation results showed that with increasing of tool rotational and decreasing tool traverse speed, the more frictional heat generates which causes formatio...
متن کاملSimulation of Tool Rotation and Travelling Speed Effects on Friction Stir Welding of Ti-6Al-4V
In this research, the effects of parameters include tool rotational and traverse speeds were investigated on heat generation and material flow during friction stir welding of Ti-6Al-4V alloy with computational fluid dynamics (CFD) method. Simulation results showed that with increasing of tool rotational and decreasing tool traverse speed, the more frictional heat generates which causes formatio...
متن کاملTool Geometry for Friction Stir Welding—Optimum Shoulder Diameter
The most important geometric parameter in the friction stir welding (FSW) tool design is the shoulder diameter, which is currently estimated by trial and error. Here, we report a combined experimental and theoretical investigation on the influence of shoulder diameter on thermal cycles, peak temperatures, power requirements, and torque during FSW of AA7075-T6. An optimum tool shoulder diameter ...
متن کاملJoining of Commercial Pure Copper via Self-reacting Friction Stir Welding
Three mm thick plates of commercial pure copper were welded via friction stir welding method using a floating bobbin tool. The effect of different process variables such as the tool transverse speed and the tool rotation speed were examined in order to create a weld with the desired properties. A defect-free weld was obtained at a rotation speed of 1400 rpm and a transverse speed of 18 mm/min w...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISRN Materials Science
سال: 2013
ISSN: 2090-6099
DOI: 10.1155/2013/978031