Optimum Parameter Decision Method for Pole Transformer Tap Considering Distributed Resources
نویسندگان
چکیده
منابع مشابه
Optimal Transformer Tap Selection Using Modified Barrier-Augmented Lagrangian Method
The optimal tap selection of transformers directly connected to generators is one of the two significant industry problems. The generator stepup and auxiliary transformers generally are equipped with no-load (fixed) taps that are infrequently changed. Their optimum positions need to be determined for meeting power system discrete states over long periods, covering the annual light-load, peak-lo...
متن کاملAllocation of Distributed Energy Resources for Microgrid Optimal Scheduling Considering Uncertainty
In this paper, a microgrid including a solar panel, a battery energy storage system and a diesel generator as the backup source are optimally is designed. The microgrid is considered as a part of a distribution network, that could be considered as local area. As microgrids can operate in grid-connected mode, the proposed algorithm investigates the minimization of the distribution network power ...
متن کاملA New Procedure for Reactive Power Market Clearing Considering Distributed Energy Resources
Traditionally, conventional generation unit was used to provide ancillary services e.g. reactive power support, and spinning reserve. Nonetheless, with the emergence of highly penetrated distributed energy resources (DERs) systems and considering how beneficial they can be; it appears reasonable to use them as reactive power providers. Therefore, this paper introduces a new procedure for DERs t...
متن کاملOptimum parameter for the SOR-like method for augmented systems
Recently, several proposals for the generalization of Young’s SOR method to the saddle point problem or the augmented system has been presented. One of the most practical versions is the SOR-like method given by Golub et al., [(2001). SOR-like methods for augmented systems. BIT, 41, 71–85.], where the convergence and the determination of its optimum parameters were given. In this article, a ful...
متن کاملTransformer voltage control and Tap changing
The voltage control is performed by changing the turns ratio. This is done by provision of taps in the winding. The volts per turn available in large transformers is quite high and hence a change of even one turn on the LV side represents a large percentage change in the voltage. Also the LV currents are normally too large to take out the tapping from the windings. LV winding being the inner wi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Power and Energy
سال: 2007
ISSN: 0385-4213,1348-8147
DOI: 10.1541/ieejpes.127.137