Optimum Compressive Strength of Hardened Sandcrete Building Blocks with Steel Chips
نویسندگان
چکیده
منابع مشابه
Copper Precipitation Hardened, High Strength, Weldable Steel
Steel containing 0.03% carbon, 1.35% copper and 0.84% nickel had yield strength in the 540-625 MPa (78-90 Ksi) range depending on thickness, ultimate tensile strength in the 625-690 MPa (90100 Ksi) range, and 25-30% elongation when air cooled after hot rolling. No brittle heat-affected zone was formed during manual or automatic submerged arc welding without pre-heating or postheating. The fract...
متن کاملGranite Fines as a Partial Replacement for Sand in Sandcrete Block Production
Sandcrete block, being one of the most important building materials, has become very expensive nowadays and it’s on high demand in Nigeria. In order to reduce its cost and probably increase the compressive strength, this research was conducted to assess the suitability of granite fines as partial replacement for sand in sandcrete block production. The mix proportion (1:6) was used for batching ...
متن کاملNumerical validation of compressive strength prediction for hollow concrete blocks
The results of a numerical modeling program to evaluate the behavior of hollow concrete blocks under uniaxial compression are addressed. It has been considered appropriate to use interface elements to represent the confinement effect at the top and bottom of blocks. The response of the numerical simulations is compared with experimental data of masonry units. Laboratory tests were carried out u...
متن کاملFinite Element Analysis of Hardened Steel Cutting
Hard machining, as attractive replacement for many rough and finish grinding operation, generates high cutting forces and temperature that enhance tool wear when act together. Therefore, the tool geometry and machining parameters have to be carefully optimized for a given material. Because of high cost and time consuming experimental work up-to-date advanced software for modeling and simulation...
متن کاملSaw Dust Ash as Partial Replacement for Cement in the Production of Sandcrete Hollow Blocks
This study investigates the use of Saw Dust Ash (SDA) as partial replacement for ordinary Portland cement (OPC) in sandcrete blocks. Some units of sandcrete hollow blocks were produced by partially replacing the cement content with 5% to 25% by weight of SDA, using vibrating block moulding machine. Sandcrete blocks without SDA serve as the control. The blocks produced were tested to determine t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Buildings
سال: 2013
ISSN: 2075-5309
DOI: 10.3390/buildings3010205