Optimizing the Required Cathodic Protection Current for Pre-Buried Pipelines Using Electrochemical Acceleration Methods

An Electrochemical Measurement for Evaluating the Cathodic Disbondment of Buried Pipeline Coatings under Cathodic Protection

Steel pipelines are susceptible to corrosion by the action of corrosive substance in the environment and one of the most common failure modes in buried pipeline coatingis cathodic disbondment. Consequently, Electrochemical Impedance Spectroscopy (EIS) was used to assess the effect of three important parameters, the thickness of coating, the artificial defect ...

an electrochemical measurement for evaluating the cathodic disbondment of buried pipeline coatings under cathodic protection

steel pipelines are susceptible to corrosion by the action of corrosive substance in the environment and one of the most common failure modes in buried pipeline coatingis cathodic disbondment. consequently, electrochemical impedance spectroscopy (eis) was used to assess the effect of three important parameters, the thickness of coating, the artificial defect and electrolyte type, on cathodic di...

Cathodic Corrosion Protection of earthburried Pipelines

Evaluation of Seismic Protection Methods for Buried Fuel Pipelines Subjected to Fault Rupture

Buried steel fuel pipelines are critical lifelines for the society and the economy but are very vulnerable to earthquake-induced ground failure. Traversing seismic areas inevitably results in several pipe-fault crossings. Fault rupture forces a buried pipeline to undergo deformations that could be substantial and heavily endanger its integrity. Due to the grave consequences of a potential pipe ...

Refinement to the Existing Analytical Methods of Analysis of Buried Pipelines due to Strike-Slip Faulting

Analytical methods presented to analyze the buried steel pipelines at strike-slip fault crossing use the Euler-Bernoulli beam theory. The cross-section of a buried pipe that is completely surrounded by soil cannot rotate freely and would not be remained perpendicular to the bending line after deformation. So it would be better to take into consideration a rotation between the cross-section and ...