Optimizing synthesis parameters of short carbon fiber reinforced polysulfonamide composites by using response surface methodology
نویسندگان
چکیده
منابع مشابه
Effect of Fiber Surface Treatment on Wear Characteristics of Carbon Fiber Reinforced Polyamide 6 Composites
Ozone modification method and air-oxidation were used for the surface treatment of polyacrylonitrile(PAN)-based carbon fiber. The surface characteristics of carbon fibers were characterized by X-ray photoelectron spectroscopy (XPS). The interfacial properties of carbon fiber reinforced polyamide 6 (CF/PA6) composites were investigated by means of the single fiber pull-out tests. As a result...
متن کاملCarbon Fiber Reinforced Bismaleimide Composites
Bismaleimide (BMI) resins are developed very rapidly due to the demands of the defense and aerospace industries. They are cross-linked polymers which process like epoxy resins but have an upper use temperature of 230°C, compared to the epoxy upper use temperature of 175°C. Also due to the available intrinsic properties of BMI resins such as higher thermal stability and lower toxicity than those...
متن کاملResponse Surface Methodology for Optimizing Hyper Parameters
The performance of an algorithm often largely depends on some hyper parameter which should be optimized before its usage. Since most conventional optimization methods suffer from some drawbacks, we developed an alternative way to find the best hyper parameter values. Contrary to the well known procedures, the new optimization algorithm is based on statistical methods since it uses a combination...
متن کاملpreparation and characterization of new co-fe and fe-mn nano catalysts using resol phenolic resin and response surface methodology study for fischer-tropsch synthesis
کاتالیزورهای co-fe-resol/sio2و fe-mn-resol/sio2 با استفاده از روش ساده و ارزان قیمت همرسوبی تهیه شدند. از رزین پلیمری resol در فرآیند تهیه کاتالیزور استفاده شد.
Processing of Carbon Fiber Reinforced Composites by Three Dimensional Photolithography
The reinforcement of photoresins with continuous carbon fibers is discussed in this paper. The processing was conducted in an automated desktop photolithography unit (ADPU) developed and built in-house. Continuous fibers were added in situ to the photoresin to obtain composite samples containing over 20 vol% of the fibers. The tensile strength of these composites improved by at least a factor o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Polymer Testing
سال: 2017
ISSN: 0142-9418
DOI: 10.1016/j.polymertesting.2017.02.013