Optimizing surface finish in WEDM using the taguchi parameter design method
نویسندگان
چکیده
منابع مشابه
Surface Quality Finish in Laser Cutting Using Taguchi Design
Original scientific paper The present work aims at obtaining parametric combination to achieve the best surface finish and assess effects of selected process parameters on a laser cut quality for laser cutting. This helps to study the variation in response parameter (Ra value) for various levels of selected process parameters. In the present work mild steel specimen is used and the effect of th...
متن کاملOptimizing Surface Roughness and Flank Wear on Hard Turning Process Using Taguchi Parameter Design
This paper presents an application of the Taguchi method parameter design to optimize the surface roughness, tool wear and cutting force by hard turning process. The Taguchi parameter design method is an efficient method in which response variable can be optimized, given various controls and using fewer experimental runs. Hard turning is the latest trend in all manufacturing industries and it i...
متن کاملParametric Study of Dry WEDM Using Taguchi Method
Wire Electrical Discharge Machining (WEDM) is a non-traditional thermo-electric process capable of machining hard materials of highly complex three dimensional shapes. In this paper, the dry WEDM experimentation is conducted using oxygen as a dielectric medium. The deionized water is replaced by the oxygen as a dielectric medium to ameliorate the environmental impact in the machining surroundin...
متن کاملOptimizing the Properties of Metakaolin-based (Na, K)-Geopolymer Using Taguchi Design Method
Geopolymer paste is an innovative construction material which shall be produced by chemical action of inorganic molecules. It is a more environmentally friendly alternative to conventional Portland cement which is abundantly available worldwide. In this study, the influence of different alkaline activators (Na and K) on the mechanical and thermal behaviors of metakaolin-based geopolymer was inv...
متن کاملOptimization of Material Removal Rate and Surface Roughness for WEDM of Titanium Alloy (Ti-4.5Al-2V) Using Taguchi Method
In this paper, wire electric discharge machining (WEDM) of Titanium alloy (Ti-4.5Al-2V) is studied. In WEDM, the prime objective in cutting operation is to achieve the highest possible cutting speed along with desirable surface finish without sacrificing productivity. It is evident that a high material removal rate and a very good surface finish can never be achieved simultaneously in WEDM. Sel...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Brazilian Society of Mechanical Sciences and Engineering
سال: 2010
ISSN: 1678-5878
DOI: 10.1590/s1678-58782010000200002