Optimizing Laser Powder Bed Fusion Parameters for IN-738LC by Response Surface Method
نویسندگان
چکیده
منابع مشابه
Response Surface Methodology for Optimizing Hyper Parameters
The performance of an algorithm often largely depends on some hyper parameter which should be optimized before its usage. Since most conventional optimization methods suffer from some drawbacks, we developed an alternative way to find the best hyper parameter values. Contrary to the well known procedures, the new optimization algorithm is based on statistical methods since it uses a combination...
متن کاملFunctionalization of Biomedical Ti6Al4V via In Situ Alloying by Cu during Laser Powder Bed Fusion Manufacturing
The modern medical industry successfully utilizes Laser Powder Bed Fusion (LPBF) to manufacture complex custom implants. Ti6Al4V is one of the most commonly used biocompatible alloys. In surgery practice, infection at the bone-implant interface is one of the key reasons for implant failure. Therefore, advanced implants with biocompatibility and antibacterial properties are required. Modificatio...
متن کاملStudy of the Microstructure and Cracking Mechanisms of Hastelloy X Produced by Laser Powder Bed Fusion
Hastelloy X (HX) is a Ni-based superalloy which suffers from high crack susceptibility during the laser powder bed fusion (LPBF) process. In this work, the microstructure of as-built HX samples was rigorously investigated to understand the main mechanisms leading to crack formation. The microstructural features of as-built HX samples consisted of very fine dendrite architectures with dimensions...
متن کاملResponse Surface Methodology for Optimizing Adsorption Process Parameters of Reactive Blue 21 onto Modified Kaolin
In this research modified Kaolin by Cetyltrimethylammonium bromide is used as an adsorbent for the removal of Reactive Blue 21 from aqueous solutions. Response Surface Methodology was used to study the effect of independent variables, such as Reactive Blue 21 dye concentration (20, 40, 60, 80 and 100 mg/L), time (10, 20, 30, 40 and 50), initial pH (2, 4, 6, 8 and 10) and modified Kaolin dosage ...
متن کاملSome aspects on designing for metal Powder Bed Fusion
Additive Manufacturing (AM) using the Powder Bed Fusion (PBF) is a relatively new manufacturing method that is capable of creating shapes that was previously practically impossible to manufacture. Many think it will revolutionize how manufacturing will be done in the future. This thesis is about some aspects of when and how to Design for Additive Manufacturing (DfAM) when using the PBF method i...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials
سال: 2020
ISSN: 1996-1944
DOI: 10.3390/ma13214879