Optimized Mixture Ratio in YSZ-Supported Ni-YSZ Anode Material for SOFC

نویسندگان

چکیده

برای دانلود رایگان متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Preparation of Ni-ysz Nano-fiber Composite as Fuel Cell Anode Material

A novel route to fabricate nano-fiber anode material for solid oxide fuel cells (SOFCs) is presented. Firstly, uniform nano-fibers of 8 mol % Yttria Stabilized Zirconia (8YSZ) were formed in an electrospinning process; then, these electrospun fibers were calcined at temperatures up to 1300 °C; and finally the ceramic 8YSZ nano-fibers were coated with nickel in an electroless plating process. Th...

متن کامل

Operation of Ni-YSZ Anode Supported Solid Oxide Fuel Cell on Different Simulated Syngases

Ni-YSZ anode supported solid oxide fuel cells (ASCs) were tested under various simulated syngas. There was no voltage degradation of the cell operated on 41%H2-7%CH4-6%CO-11%CO2-35%H2O fuel condition for nearly 450 hours. However, the high vapor content reduced the open circuit voltage (OCV) and discharge voltage. The cells run steadily with most dry syngas until the simulated reforming tempera...

متن کامل

An Examination of SOFC Anode Functional Layers Based on Ceria in YSZ

The properties of solid oxide fuel cell (SOFC) anode functional layers prepared by impregnation of ceria and catalytic metals into porous yttria-stabilized zirconia (YSZ) have been examined for operation at 973 K. By varying the thickness of the functional layer, the conductivity of the ceria-YSZ composite was determined to be only 0.015–0.02 S/cm. The initial performance of anodes made with ce...

متن کامل

Characterization of YSZ-YST Composites for SOFC Anodes

Porous composites of Sr0.88Y0.08TiO3-δ (YST) and yttria-stabilized zirconia (YSZ) were formed by tapecasting methods and examined as potential anodes for SOFC. Even after calcination to 1773 K, the YSZ and YST crystallites remain as separate phases, as demonstrated by XRD and SEM with EDX analysis. Furthermore, it was possible to fabricate anode-supported electrolytes by calcination of a bilaye...

متن کامل

Fabrication and Characterizations of YSZ Electrolyte Films for SOFC

Yttria stabilized zirconia (YSZ) has been widely used as electrolyte in solid oxide fuel cell (SOFC). The effect of fabrication process on the properties of YSZ electrolyte thick film is discussed in the paper. With YSZ nano-powders of about 20-60nm as raw material, YSZ green adobe was fabricated by tape calendering process. Three-step sintering process was performed firstly holding at 1000°C f...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: ECS Proceedings Volumes

سال: 2001

ISSN: 0161-6374,2576-1579

DOI: 10.1149/200116.0750pv