Optimized Injection Molding of Unfilled and Glass Filled PA6 Gears
نویسندگان
چکیده
منابع مشابه
Aging Studies of Filled and Unfilled VCE
VCE is an ethylene, vinyl acetate, vinyl alcohol elastomer used to bind high volumes of microparticles. Surveillance data for this material is both scarce and scattered, complicating the assessment of any aging trends in systems. In addition, most of the initial surveillance efforts focused on mechanical properties such as hardness and tensile strength, and chemical information is therefore lac...
متن کاملPrecision Injection Molding PRECISION PROCESS CONTROL OF INJECTION MOLDING
1 INTRODUCTION The technical requirements of precision injection molded components demand a heightened level of process performance, and with corresponding process monitoring and control technologies. To obtain the desired critical to quality attributes (CTQs) of the molded products, the injection molding process must be consciously designed such that the key process variables (KPVs) are observ...
متن کاملNeural correlates of the processing of unfilled and filled pauses
Spontaneously produced Unfilled Pauses (UPs) and Filled Pauses (FPs) were played to subjects in an fMRI experiment. While both stimuli resulted in increased activity in the Primary Auditory Cortex, FPs, unlike UPs, also elicited modulation in the Supplementary Motor Area, Brodmann Area 6. This observation provides neurocognitive confirmation of the oft-reported difference between FPs and other ...
متن کاملWear of Filled and Unfilled Dental Restrain Resins
One approach to the study of wear involves the ch~~te~zation of surface failure under conditions of single-pass sliding. Such an approach has been used to show that the wear of commercial and experimental restorative resins and composites is determined by the resistance of the material to penetration and by the mode of deformation during sliding [l] . The purpose of this investigation was to ch...
متن کاملCeramic Injection Molding
Powder injection molding (PIM), which encompasses metal injection molding (MIM) and ceramic injection molding (CIM), is a net-shaping process which enables large scale production of complex-shaped components for use in a diverse range of industries. It combines plastic injection molding techniques and performance attributes of ceramic and metal powders. Ceramic injection molding (CIM) uses cera...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Manufacturing Engineering
سال: 2014
ISSN: 2356-7023,2314-5781
DOI: 10.1155/2014/719462