Optimization of Surface Milling of Hardened AISI4340 Steel with Minimal Fluid Application Using a High Velocity Narrow Pulsing Jet of Cutting Fluid
نویسندگان
چکیده
منابع مشابه
Performance Evaluation of Different Types of Cutting Fluid in the Machining of Aisi 01 Hardened Steel Using Pulsed Jet Minimal Quantity Lubrication System
This paper presents the performance evaluation of three different cutting fluids used in a minimal quantity lubrication (MQL) system. The MQL system, developed in-house at the University of Malaya, was capable of delivering high velocity cutting fluid in narrow pulsed jet forms at a rate of 2 ml/min and a pressure of 20 MPa. The three cutting fluids chosen were neat oil, soluble oil and semi-sy...
متن کاملSimulation of a Helium Atmospheric Plasma Jet Using Fluid Equations
In this study, a cold atmospheric He plasma jet is investigated. The jet is of dielectric barrier discharge type, consisting of a dielectric tube with two metal ring electrodes. The continuity, momentum and energy conservation equations as well as the Poisson equation for obtaining the potential and the electric field, accompanied with the ideal gas laws, are used for the simulation. The result...
متن کاملMachining with Minimal Cutting Fluid
The purpose of cutting fluid in a machining operation is to cool the workpiece, reduce friction, and wash away the chips. The cutting fluid contributes significantly toward machining cost and also possesses environmental threats. In the past, there have been some attempts to minimize the amount of cutting fluid in machining. This chapter reviews some prominent ways to minimize the application o...
متن کاملAnalysis of Cutting Fluid Jet Impingement on a Flat Surface via Computational Fluid Dynamics
Cutting Fluid mist produced during machining operations is receiving increased attention by industry becasue of its adverse health effects. Thus, it is desired to obtain a fundamental understanding of the mechanisms that underlie mist formation. This knowledge can be used as a tool to design machining processes or systems that reduce the formation of cutting fluid mist and hence, the health haz...
متن کاملFinite Element Analysis of Hardened Steel Cutting
Hard machining, as attractive replacement for many rough and finish grinding operation, generates high cutting forces and temperature that enhance tool wear when act together. Therefore, the tool geometry and machining parameters have to be carefully optimized for a given material. Because of high cost and time consuming experimental work up-to-date advanced software for modeling and simulation...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Engineering
سال: 2010
ISSN: 1947-3931,1947-394X
DOI: 10.4236/eng.2010.210102