OPTIMIZATION OF CUTTING PARAMETERS FOR IMPROVING SURFACE ROUGHNESS IN TURNING OPERATION USING TAGUCHI METHOD AND ANOVA

Multi Objective Optimization of Cutting Parameters in Turning Operation to Reduce Surface Roughness and Cutting Forces

Optimization of Cutting Parameters for Surface Roughness in Turning

The optimized cutting parameters are very important to control the required surface quality. In the present study, Taguchi method is used to find the optimal cutting parameters for surface roughness (Ra) in turning. The L-18 orthogonal array, the signal-to-noise ratio & analysis of variance are employed to study the performance characteristics in turning operations of AISI-410 steel bars using ...

Application Of Taguchi Method For Optimization Of Process Parameters In Improving The Surface Roughness Of Lathe Facing Operation

Taguchi Method is a statistical approach to optimize the process parameters and improve the quality of components that are manufactured. The objective of this study is to illustrate the procedure adopted in using Taguchi Method to a lathe facing operation. The orthogonal array, signal-to-noise ratio, and the analysis of variance are employed to study the performance characteristics on facing op...

Design optimization of cutting parameters for turning of AISI 304 austenitic stainless steel using Taguchi method

In the present work Taguchi method is used to optimize cutting parameters during dry turning of AISI 304 austenitic stainless steel with AlTiCrN coated tool. The coating was deposited on fine-grained K-grade (ISO K-20) cemented carbide cutting insert using physical vapor deposition (PVD) technique. The turning parameters evaluated are cutting speed of 200 and 260 m/min, feed rate of 0.20 and 0....

Optimization of Surface Roughness of Aisi 304 Austenitic Stainless Steel in Dry Turning Operation Using Taguchi Design Method

The present work is concentrated with the dry turning of AISI 304 Austenitic Stainless Steel (ASS). This paper presents the influence of cutting parameters like cutting speed, feed rate and depth of cut on the surface roughness of austenitic stainless steel during dry turning. A plan of experiments based on Taguchi’s technique has been used to acquire the data. An orthogonal array, the signal t...