Optimization Multi Response on Electrical Discharge Machining Sinking Process Using Taguchi-Grey-Fuzzy Methods
نویسندگان
چکیده
منابع مشابه
Taguchi-grey relational based multi response optimization of electrical process parameters in electrical discharge machining
In modern machining process, optimization technique is used to find the optimal values of input parameters and the effect of those parameters on response variables. If response parameters are more than one, Taguchi method of optimization may give different set of optimal levels for each response. In the present study, Taguchi-grey relational approach based multi response optimization has been u...
متن کاملOptimization of Process Parameters of Wire Electrical Discharge Machining Using Fuzzy logic Integrated with Taguchi Method
In this paper, fuzzy logic integrated with the Taguchi method is used to optimize Wire Electro Discharge Machining (WEDM) process with multiple quality characteristics. Rough machining with EDM gives poor surface finish and has micro cracks and pores. Finish machining gives better surface finish but with very poor machining speed (MRR). Spark gap width is one of the important performance measur...
متن کاملMulti-objective optimisation of die sinking electro discharge machining process using Taguchi
The objective of this paper is to determine the optimal setting of the process parameters on the electro-discharge machining (EDM) machine while machining AISI H13 tool steel. The parameters considered are pulse current, pulse-on-time, pulse-off-time and gap voltage ; whereas the responses are Tool wear ratio (TWR) and material removal rate (MRR). The optimal setting of the parameters are deter...
متن کاملOptimization of wire electrical discharge machining (WEDM) process parameters using Taguchi method
Wire electrical discharge machining (WEDM) is extensively used in machining of conductive materials when precision is of prime importance. Rough cutting operation in WEDM is treated as a challenging one because improvement of more than one machining performance measures viz. metal removal rate (MRR), surface finish (SF) and cutting width (kerf) are sought to obtain a precision work. Using Taguc...
متن کاملAn Optimization on the DIN1.2080 Alloy in the Electrical Discharge Machining Process Using ANN and GA
Electrical Discharge Machining (EDM) process is one of the most widely used methods for machining. This method is used to form parts that conduct electricity. This method of machining has used for hard materials and therefore selects the correct values of parameters which are so effective on the quality machining of parts. Reaching to optimum condition of the DIN1.2080 alloy (D3) machining is v...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International journal of science, engineering, and information technology
سال: 2020
ISSN: 2548-4214
DOI: 10.21107/ijseit.v4i2.6705