Optimising small hydrocyclone design using 3D printing and CFD simulations
نویسندگان
چکیده
منابع مشابه
Optimising low molecular weight hydrogels for automated 3D printing.
Hydrogels prepared from low molecular weight gelators (LMWGs) are formed as a result of hierarchical intermolecular interactions between gelators to form fibres, and then further interactions between the self-assembled fibres via physical entanglements, as well as potential branching points. These interactions can allow hydrogels to recover quickly after a high shear rate has been applied. Ther...
متن کاملDesign Optimization Strategy for Multifunctional 3D Printing
An optimization based design methodology for the additive manufacture of multifunctional parts (for example, a structure with embedded electronic/electrical systems and associated conductive paths) is presented. This work introduces a coupled optimization strategy where Topology Optimization (TO) is combined with an automated placement and routing approach that enables determination of an effic...
متن کاملComputational Prediction of Wind Induced Virations in Silo Groups Using 2d and 3d Cfd Simulations
Wind induced ovalling vibrations were observed during a storm in October 2002 on several empty silos of a closely spaced group consisting of 8 by 5 thin-walled silos in the port of Antwerp (Belgium). To clarify the cause and location of the observed silo vibrations, a thorough analysis of the aerodynamic pressures on the silo surfaces is required. Therefore, both 2D and 3D computational fluid d...
متن کاملInvestigation of wind induced vibrations of silos using 2D and 3D CFD simulations
Wind induced ovalling vibrations were observed during a storm in October 2002 on several empty silos of a closely spaced group consisting of 8 by 5 thin-walled silos in the port of Antwerp (Belgium). To clarify the cause and location of the observed silo vibrations, a thorough analysis of the aerodynamic pressures on the silo surfaces is required. Therefore, both 2D and 3D computational fluid d...
متن کاملDesign and Manipulation 3D Imaging System by using Photodiode Grid
Introduction: Radiation imaging is one of the applicable methods in diagnostic medicine and nondestructive testing for industrial applications. In nondestructive 3D imaging, in addition to the radiation source, there is a requirement for a suitable detection system, data acquisition system, mechanical sections for moving objects, reconstruction algorithm and finally a computer for processing an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Chemical Engineering Journal
سال: 2018
ISSN: 1385-8947
DOI: 10.1016/j.cej.2018.06.016