Optimising Reactive Compensation in Power System
نویسندگان
چکیده
منابع مشابه
Simulation of Power System Response To Reactive Power Compensation
I am submitting herewith a thesis written by Pierre Alexandre Bohême entitled " Simulation of Power System Response to Reactive Power Compensation. " I have examined the final electronic copy of this thesis for form and content and recommend that it be accepted in partial fulfillment of the requirements for the degree of Master of Science, with a major in Electrical Engineering. (Original signa...
متن کاملDynamic compensation of reactive power in Various Faults in Power System
The STATCOM (Synchronous Static Compensator) based on voltage source converter (VSC) is used for voltage regulation in transmission and distribution system. The STATCOM can rapidly supply dynamic VARs required during system faults for voltage support. Strict requirements of STATCOM losses and total system loss penalty preclude the use of PWM (Pulse-Width Modulation) for VSC based STATCOM applic...
متن کامل“Compensation of Reactive Power Using D-STATCOM”
The D-STATCOM is a shunt connected FACTS device which supplies reactive power to the load to improve the voltage stability of the load busses. The D-STAT COM in multi bus system is capable of reducing the losses and improving the voltage regulation.This work deals with comparison of Push Pull and Voltage Inverter based D-STATCOM for multi bus system. Eight bus system is modeled using the elemen...
متن کاملSimulation of Reactive Power Compensation Using STATCOM
Power quality in distribution systems has been attracting an increasing interest during recent years. Research studies include the quality of voltage supply with connected to the same point of common coupling (PCC). Utility distribution networks, sensitive industrial loads and critical commercial operations suffer from various types of outages and service interruptions which can cost significan...
متن کامل1 . Reactive Power Compensation of Transmission Lines
1.1 General Introduction During the past two decades, the increase in electrical energy demand has presented higher requirements from the power industry. More power plants, substations, and transmission lines need to be constructed. However, the most commonly used devices in present power grid are the mechanically-controlled circuit breakers. The long switching periods and discrete operation ma...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Electrical and Power Engineering
سال: 2012
ISSN: 1990-7958
DOI: 10.3923/ijepe.2012.13.18