Optimisation of bitumen emulsion properties for ballast stabilisation

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Cold in-place recycling with bitumen emulsion

The cold in-place recycling (CIPR) is a process where the existing bituminous pavement is recycled without application of heat. In CIPR process the scarified material from the existing pavement is crushed to the required gradation and binder in cold form (emulsion or cutback or foamed bitumen) is added. Externally acquired Reclaimed Bituminous Pavement (RBP) or fresh aggregates are also added d...

متن کامل

modification of nanoclay for improving the physico-mechanical properties of dental adhesives

هدف اصلی این مطالعه تهیه یک سامانه نوین چسب عاجی دندانی بر پایه نانورس پیوند شده با پلی متاکریلیک اسید، نانورس پیوند شده با پلی اکریلیک اسید، مخلوط نانوسیلیکا و نانورس پیوند شده با پلی متاکریلیک اسید، مخلوط نانوسیلیکا و نانورس پیوند شده با پلی اکریلیک اسید و نانورس پیوند شده با کیتوسان اصلاح شده با گلایسیدیل متاکریلات است. پیوند پلی متاکریلیک اسید و پلی اکریلیک اسید بر ری سطح نانورس در حضور و ...

Characterization of Kaolinite ζ Potential for Interpretation of Wettability Alteration in Diluted Bitumen Emulsion Separation

Initial processing of Athabasca oil sands obtained from the water-based extraction process yields stable water-in-bitumen emulsions.When the bitumen is diluted with naphtha to reduce its viscosity and density, partial separation can be obtained with a suitable demulsifier. However, a “rag layer” forms between the clean oil and free water layers. The partially oil-wet kaolinite in clay solids ca...

متن کامل

Rheological properties of modified Bitumen: Comparison of waste polymers’ performance

In this investigation, rheological properties of three different polymer-modified bitumen compounds containing recycled polyethylene terephthalate (R-PET), crumb rubber (CR) and poly (styrene-butadiene-styrene) (SBS) are evaluated and compared. The modified samples were tested by a dynamic shear rheometer (DSR) where complex modulus (G*), phase angle (δ) and rutting resistance (G*/Sinδ) of spec...

متن کامل

Association of Asphalt Paving Technologists A Study of Cement Modified Bitumen Emulsion Mixtures

Earlier studies have demonstrated the beneficial effects of adding Ordinary Portland Cement (OPC) to bitumen emulsion mixtures. These effects were confirmed for some dense graded mixtures based on recipes currently used for hot mix in the UK and being considered for use in cold mix. Laboratory tests included stiffness modulus, resistance to permanent deformation and resistance to fatigue cracki...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Materiales de Construcción

سال: 2017

ISSN: 1988-3226,0465-2746

DOI: 10.3989/mc.2017.04416