Optimal tightening process of bolted joints
نویسندگان
چکیده
منابع مشابه
Bolted Joints in Laminated Composites
Expressions were presented which can be used to estimate the strengths of continuous fiber reinforced composite laminates containing pin-loaded holes. The expressions apply to laminates containing either a single pin loaded hole, a single row of pin loaded holes, or two parallel rows of pin loaded holes.
متن کاملIdentification of Bolted Joints through Laser Vibrometry
We present a new technique for identifying the dynamics of bolted joints. The technique relies on the comparison of the overall dynamics of the bolted structure to that of a similar but unbolted one. The di!erence in the dynamics of the two systems can be attributed solely to the joint; modelling this di!erence in the dynamics enables us to construct a non-parametric model for the joint dynamic...
متن کاملBolted Timber Joints with Self-tapping Screws
The use of self-tapping screws with continuous threads in the joint area as a reinforcement to avoid splitting of timber members is studied. A theoretical model is developed to calculate the stress distribution around a pin-loaded hole in a timber joint, to predict brittle failure modes in bolted connections and to calculate the load in the reinforcing screws. Laboratory experiments on reinforc...
متن کاملTransient Thermal and Structural Analysis of Cylinder and Bolted Joints on BOG Compressor During Starting Process
BOG (Boil off Gas) compressor deals with the gas evaporated from the LNG storage tank. Its working temperature is lower than-120℃. There are two types of starting process for BOG compressor: Direct Starting and No-load Starting. During the starting process, the temperature on cylinder will change rapidly and result in additional thermal stress to some parts on the cylinder, especially to the bo...
متن کاملAnalytical Modeling of Thermal Resistance in Bolted Joints
An analytical approximate solution is developed for predicting the thermal resistance of bolted joints between two square plates . of the same material but different thicknesses. The plates are assumed to have perfectly flat and smooth surfaces, and they are joined by a bolted connection at the center of the square, forming a concentric annular contact region at the interface. The entire surfac...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal for Simulation and Multidisciplinary Design Optimization
سال: 2016
ISSN: 1779-627X,1779-6288
DOI: 10.1051/smdo/2016005